compustar cm3300 arming

Home / the12volt's Install Bay / Car Security and Convenience / compustar cm3300 arming (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

mkee

Member - Posts: 7

Joined: January 28, 2008

Location: British Columbia, Canada

Posted: March 21, 2008 at 8:30 PM / IP Logged

After installing the CM3300 alarm in my garage everything working good, the alarm arms and disarms normally, power door locks, locks and unlocks. But when I go out somewhere parked the alarm does not arm and no response with the remote, only thing working is the door locks with ignition on or off. Any one know the problem?

tedmond

Gold - Posts: 4,610

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: January 06, 2007

Location: Ontario, Canada

Posted: March 22, 2008 at 7:24 AM / IP Logged

reset your unit and make sure you got a good ground. Another issue could be that your antenna cable is not plugged in firmly, it might have gotten dissconnected when you were putting your dash back.

chadwa2003

Copper - Posts: 353

Joined: January 08, 2005

Location: Canada

Posted: March 22, 2008 at 8:44 AM / IP Logged

It may be in valet mode if the doors lock. Do the parking lights flash? If they don't then it is in valet mode

mkee

Member - Posts: 7

Joined: January 28, 2008

Location: British Columbia, Canada

Posted: March 22, 2008 at 12:18 PM / IP Logged

Thanks for the info, I will check it out today. How do I reset, is it disconnect the 12V from the module and start over again? I did noticed there was 3 chirps in arming and disarming, saying something is not right.

Chris Luongo

Platinum - Posts: 3,746

This member consistently provides reliable information

Joined: May 21, 2002

Location: Massachusetts, United States

Posted: March 22, 2008 at 1:58 PM / IP Logged

I'm not too familiar with Compustar, but I believe you can put their units into/out of valet by pressing button combinations on the remote.

Usually they print a little guide on the back of the remote too.

Chris Luongo

Platinum - Posts: 3,746

Joined: May 21, 2002

Location: Massachusetts, United States

Posted: March 22, 2008 at 2:00 PM / IP Logged

Also when tedmond said to make sure you have a good ground........

I have a friend who installs a lot of Compustar. He told me just yesterday, that if the voltage to the alarm brain drops too low, the system will put itself into valet mode.

If it keeps going into valet mode over and over again, check to see if you have a poor constant or ground connection to the alarm, or if your car battery is in bad condition.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

compustar cm3300 arming

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.