intellistart programing

hi guys was wondering if any one can advise .i have a concept 650 g5 with tellistart .i had to have a new battey on my car and all my settings were lost ive managed to set most of it back up via the plain veiw buttons exept the tellistart functions.i had it set for manual car and when you pull over ,push the ** button to activate tellistart and  that its in neutral,take the keys out and the car would keep running untill armed then turn itself off..then push the * button to start.can i set this back up via plain veiw buttons? it seems all the buttons have taken on new functions

Use a Wiz to check the functions of your remotes, ** button was never meant to be remote start manual enable. I think it was G5 + **

wiz?thats how it was set up and it worked fine for me i just wanted to c if i could set it up myself rather than pay £30 for some one else to set it up,if i purchased the cliffnet software could i do it via that?

So you won't pay £30 to have it done properly, the Wiz will cost you that money, the software you get is not the software I get and even so it's ful of glitches you will end up tearing your hair out. Have it done professionally. One company I used to work for wouldn't entertain warante work if we found the cusrtomer had used Wiz. Leave it alone its for pros only.