Installing an Alarm. I got questions

Ok. I just recently bought the AlphaGuard A90. ( http://www.concordia-auto.com   (A88)). Now my truck doesn't have power locks so I just wanted to know how I would add central locking to my truck through the alarm? I bought two actuators that only have two leads which prob means that you have to reverse polarity to get it to lock/unlock.

Yup. Basically install the motors and run the wires to a common place near the alarm preferred. Then depending on the output of the alarm you would wire two relays like this:for locks-85 lock output from the alarm, 86 opposite polarity of the lock output(if lock is neg then this would be pos), 30 lock motor wire, 87a ground, 87 +12V. For unlock every thing is the same except 85 would be the unlock output and 30 would be unlock motor. Here is a diagram https://www.the12volt.com/doorlocks/page3.asp#arpCertified Security Specialist

Always check info with a digital multimeter.

I promise to be good.

Tell Darwin I sent you.

I've been sick lately, sorry I won't be on much.