2008 dodge chager wiring info

Installing a simple alarm in a 08 Chager, does anybody have a wiring diagram they can share?  Any problems with this vehicle?

Thanks

Steve

	Battery		LIGHT BLUE/RED		(+)		IGNITION SWITCH HARNESS
	Ignition 1		PINK/WHITE		(+)		IGNITION SWITCH HARNESS
	Starter 1		YELLOW/GRAY		(+)		AT TIPM MODULE BEHIND RIGHT HEADLAMP UNDER HOOD
	All Door Trigger		YELLOW/WHITE		(+)		IN HARNESS IN PASSENGER SIDE WINDSHIELD PILLAR
	LF Latch		VIOLET		(-)		IN HARNESS IN DRIVER KICKPANEL
	RF Latch		VIOLET/WHITE		(-)		IN HARNESS IN PASSENGER KICKPANEL
	LR Latch		VIOLET/GRAY		(-)		IN HARNESS IN DRIVER KICKPANEL
	RR Latch		VIOLET / YELLOW		(-)		IN HARNESS IN PASSENGER KICKPANEL
	Trunk Trigger		VIOLET/ORANGE		(-)		IN HARNESS IN PASSENGER KICKPANEL
	Parking Lights		WHITE/ VIOLET		(+)		IN HARNESS IN PASSENGER KICKPANEL
	Low Crr Pk Lights		WHITE/ BROWN		(-)		AT VEHICLE HEADLIGHT SWITCH

Notes    starter wire in not for remote start.  A module is needed for that.        2. To avoid domelight delay catch latch wires individually and diode isolate each wire.  3. Individual latch wires are also in harness of instrument cluster.  4. Trunk trigger also in guage harness.  5. Parking lights require the use of a 1.6K resistor.    6. Low current parking lights note is as follows  (-) THROUGH 1.6K OHM RESISTOR, MUST ISOLATE FROM SWITCH WITH RELAY

Notice that there is a polarity difference between the parking lights and the low current parking lights.