Programing Viper Remote

its easy. first find the valet button, next, do these steps without too much hesitation in between ok. turn the key to ignition or run position. DO NOT START next press the valet button once, release it completely, then press it again and hold it, dont let go! now while you are still holding the valet button press the arm button on your new keypad. after this you can let go of the valet button and you should be done. if by some chance the remote start button doesn't work, you just start over and repeat the same steps EXCEPT you need to press and release the valet button 5 times then press it again and hold it. while you are still holding it press the remote start button once on the keypad and then you can let go and turn off the ignition. test it and then you are done

Thanks!  I will try it when I get home.

soundnsecurity wrote: if by some chance the remote start button doesn't work, you just start over and repeat the same steps EXCEPT you need to press and release the valet button 5 times then press it again and hold it. while you are still holding it press the remote start button once on the keypad and then you can let go and turn off the ignition. test it and then you are done

Just to be clear, if I end up having to use this method, do I press the valet once, release it completely, then press and release it 5 more times?

I used the first procedure and it worked! Remote start and all. Wow! That was easy.    Why couldn't they have just written it that way?!?! Thanks "Soundnsecurity"!!

turtlesplatter wrote: I used the first procedure and it worked! Remote start and all. Wow! That was easy.    Why couldn't they have just written it that way?!?! Thanks "Soundnsecurity"!!

cuz they want to discourage you so you will go pay a shop to do it for you

Hi I just received a viper 488v remote and need to program it/ Probably a dumb question but, Is the valet switch a small black push button that is attached with a led in my fuse box?? thanks