97 sunfire passlock1

I installed a prostart along with a DEI 556lw in my 97 Sunfire. The problem I am having is getting the 556 to learn the resistance. I followed the book on how to program it cycle the key on off 2 times then start them car. The status led on the 556 doesn't blink like it's suppose to it just stays on. This is how I wired the 556 in brackets is where I wired the harness to on the car. GREEN/ BLACK—(not used) BLACK/ WHITE—(-) bulb check (black wire in black connector on left side of key cylinder) BLACK—Passlock ground (Ground) PINK—(+) ignition (Pink ignition wire) BLUE—(-) status input (Ground when running on Remote Start) VIOLET—(-) crank input (to ground through relay on start wire) RED—(+) 12V (constant 12v) WHITE—(not used) YELLOW—key side resistance in (yellow passlock wire key side) WHITE/ YELLOW—(not used) BLACK / YELLOW—vehicle side resistance out (yellow passlock wire vehicle side) If someone could help me out it would be greatly appreciated this is my first time doing a remote start but I'm not new to electrical.

I have a relay on the start wire which sends the violet wire to ground while the engine is being started