viper 5901, 2006 jeep wrangler

Hi,

I am in the process of installing a Viper 5901 unit.I am okay installing and configuring the alarm portion without complications.I need assistance with the remote start installation – specifically H3 and remote start sections.On the H3 section:H3/1 – pink – ignition 1 input/outputH3/2 – RED / violet – (+) 30a fused ignition 2 / flex relay input 87H3/3 – orange – accessory outputH3/4 – violet – starter outputH3/5 – green – starter inputH3/6 – red (+) 30a fused ignition 1 relay inputH3/7 – pink/white – (+) ignition 2 flex relay outputH3/8 – pink/black – 87a of ignition 2 flex relayH3/9 – RED / black – (+) 30a fused accessory/starter relay inputsRemote start 5 pin input1 – BLACK/ white – (-) neutral safety switch2 – violet/white – tachometer input wire3 – brown – (+) brake shutdown input wire4 – gray – n/o or n/c (-) hood pin switch input5 – blue/white – (-) 2nd status / rear defogger output

Remote start 5 pin aux output are all (-) and 200ma

1 – pink/white – flex relay control output2 – orange - accessory output3 – violet - starter output4 – pink – ignition 1 ouput5 – blue – status output

On my 2006 Jeep Wrangler X, I have the directechs vehicle printout and am using:

https://www.the12volt.com/installbay/forum_posts.asp~TID~86038I have a normal key – no special computer chip.Starter – pink/orange + Ignition – pink/lt.green +Brake wire – WHITE/ tan +Hood pin – from boxNo second or third ignition

I have read the relay wiring section from the forum

https://www.the12volt.com/relays/page2.asp

I think I am making this harder than it looks by reading into the manual several time on the above sections. Could someone please help me with wiring the starter kill relay or do I need the relay?

Thank you in advance for the help and sorry for the long post – just wanted to be thorough.Rick 

I forgot to put Automatic transmission - sorry.