the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

valet 561r remote start in 2001 suburban

Home / the12volt's Install Bay / Car Security and Convenience / valet 561r remote start in 2001 suburban (Topic Closed Topic Closed)
Welcome Guest :)

Post ReplyPost New Topic
< Prev Topic Next Topic >
chuckysub 
Member - Posts: 5
Member spacespace
Joined: December 21, 2009
Location: Tennessee, United States
Posted: December 21, 2009 at 10:28 PM / IP Logged  

Will a Valet 561R Remote Starter work in a 2001 Suburban? I have connected all the wires according to the wiring guide below. The door locks work like they should but the remote starter doesn't do anything at all. Nothing clicks or makes any sound from the remote starter when I press the button on the transmitter. I am using Xpresskit PLJX for the passlock 2 system on my suburban which was recommended from a local shop. After reading some of the posts on here, could it be that I'm using the wrong bypass kit? Will using Bypasskit GMBP do the trick? It seems a whole lot easier to connect.

Thanks for any help you guys can provide.

Chuck

 MODEL YEAR(S)
 SUBURBAN  2001 -2002
 KEY T-HARNESS IMMOBILIZER
  N/A   N/A   GM's PASSLOCK 2 ANTI-THEFT System, Requires 791 or GMBP Bypass Module
 PART  COLOR LOCATION
 12 VOLT CONSTANT RED (+)  IGNITION SWITCH HARNESS
 STARTER YELLOW (+)  IGNITION SWITCH HARNESS
 STARTER 2 N/A 
 IGNITION 1 PINK (+) IGNITION SWITCH HARNESS
 IGNITION 2 WHITE (+) See NOTE *5 IGNITION SWITCH HARNESS
 IGNITION 3 N/A  
 ACCESSORY /HEATER BLOWER 1 ORANGE (+)  IGNITION SWITCH HARNESS
 ACCESSORY /HEATER BLOWER 2 N/A  
 KEYSENSE LIGHT GREEN (-)  IGNITION SWITCH HARNESS
 PARKING LIGHTS ( - ) WHITE (-)  @ BCM, LIGHT BLUE Plug, Pin A5, See NOTE *1
 PARKING LIGHTS ( + ) BROWN (+)  @ BCM, LIGHT BLUE Plug, Pin B6, See NOTE *1
 POWER LOCK LIGHT BLUE (TYPE A)  @ BCM, BROWN PLug, Pin A4, See NOTE *1
 POWER UNLOCK WHITE (TYPE A)  @ BCM, BROWN Plug, Pin A3, See NOTE *1
 DOOR TRIGGER See NOTE *2  @ BCM, See NOTE *1
 DOMELIGHT SUPERVISION TAN (-)  @ BCM, PURPLE Plug, Pin B4, See NOTE *1
 TRUNK RELEASE N/A  
 SLIDING POWER DOOR N/A  
 HORN BLACK (-)  @ STEERING COLUMN HARNESS
 TACH WHITE  @ ECM, See NOTE *3
 WAIT TO START LIGHT See NOTE *4  
 BRAKE WHITE (+)  @ SWITCH ABOVE BRAKE PEDAL
 FACTORY ALARM DISARM  LIGHT GREEN (-)  @ BCM, PURPLE Plug, Pin B3, See NOTE *1
 ANTI-THEFT YELLOW (+), ORANGE / BLACK (-) and RED / WHITE (Not used)  GM's PASSLOCK 2 System

chriswallace187 
Gold - Posts: 1,661
Gold spacespace
Joined: March 11, 2002
Location: Pennsylvania, United States
Posted: December 22, 2009 at 6:09 AM / IP Logged  
Check your neutral safety switch, as well as the hood switch.
With a 561R and a bypass problem, the lights would flash and ignition would power up before it failed to start.
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
chuckysub 
Member - Posts: 5
Member spacespace
Joined: December 21, 2009
Location: Tennessee, United States
Posted: December 22, 2009 at 12:32 PM / IP Logged  
Does my 2001 Suburban have a netural safety switch? I did not see it listed anywhere in the diagram I am using. The hood pin switch is installed as well. If it has one, where is it?
chuckysub 
Member - Posts: 5
Member spacespace
Joined: December 21, 2009
Location: Tennessee, United States
Posted: December 22, 2009 at 1:16 PM / IP Logged  

After reading a bit more. I think I have it. I will connect one end of the neutral safety switch to the remote starter and the other end to ground. I have the hood pin switch connected as well. Hopefully it works.

chriswallace187 
Gold - Posts: 1,661
Gold spacespace
Joined: March 11, 2002
Location: Pennsylvania, United States
Posted: December 22, 2009 at 2:47 PM / IP Logged  
As long as the gray/white wire is grounded, it won't interfere with remote start. You can keep the toggle switch if you like or just connect the wire to ground directly.
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
chuckysub 
Member - Posts: 5
Member spacespace
Joined: December 21, 2009
Location: Tennessee, United States
Posted: December 27, 2009 at 4:50 PM / IP Logged  

Today I finally got the remote starter to function. It attempts to crank the engine. Key word, attempts. The problem now is that it won't crank over to actually start. After reading the manual on the PLJX, I think that the truck goes into long tamper mode when I try to remote start it. It takes about 10 minutes before my truck will manually start after attempting to start the truck remotely. I have tried to program the resistor code on the PLJX and connect the 2nd status wire coming from the remote starter to the brown input wire of the PLJX but still come up with the same thing. I am at least progressing in getting the remote starter to work but now need it to crank over. Thanks for any help anyone can provide.

Chuck

jperez_jr_ 
Member - Posts: 10
Member spacespace
Joined: February 12, 2007
Location: United States
Posted: December 27, 2009 at 7:54 PM / IP Logged  

Did you get the tach wire correctly, if not try VOltage mode with the threshold set to low.

Jorge Perez
chriswallace187 
Gold - Posts: 1,661
Gold spacespace
Joined: March 11, 2002
Location: Pennsylvania, United States
Posted: December 27, 2009 at 8:31 PM / IP Logged  
Ideally you should use the blue status output from the 4 pin connector. It works exactly when the bypass needs it to, whereas the 2nd status/defroster output will do no good in that case if it accidentally gets programmed as "latched" or "pulsed".
C Renner's Auto Electronix
My service is cheap, quick, and good - pick any two
chuckysub 
Member - Posts: 5
Member spacespace
Joined: December 21, 2009
Location: Tennessee, United States
Posted: December 27, 2009 at 10:00 PM / IP Logged  

I tried the blue status output from the 4 pin satellite harness and still won't crank over to start. I will pick up a DLPKGM tomorrow and see if it works or not.

Chuck


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Thursday, May 2, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved • Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer