remote starter wiring

Home / the12volt's Install Bay / Car Security and Convenience / remote starter wiring (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

49 chevy guy

Member - Posts: 2

Joined: January 06, 2010

Location: Kansas, United States

Posted: January 06, 2010 at 7:59 PM / IP Logged

i have a 1996 honda civic dx and i am wiring up a remote starter for it. in the instructions it says there is a wire that has to go to neg. when running. does anyone know where i can find that or how to find that. thank you very much for your help.

Back to Top

Twelvoltz

Platinum - Posts: 2,384

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: March 24, 2005

Location: New Jersey, United States

Posted: January 06, 2010 at 8:32 PM / IP Logged

What is the make and model of the system you are installing? The wire you are talking about is probably a low current negative output, not an input and as such probably not needed in your application.

Installer, IT support, and FFL. I need less hobbies.

Back to Top

clapclapngo

Member - Posts: 7

Joined: January 03, 2010

Location: New York, United States

Posted: January 06, 2010 at 11:26 PM / IP Logged

If it says the wire goes to negative that usually means ground. In which case you would attach it to a clean bare metal part of car chasis. Your question is kinda vague so cant say for sure.

Back to Top

jim hunter

Silver - Posts: 351

Joined: March 23, 2006

Location: United States

Posted: January 07, 2010 at 9:58 PM / IP Logged

neg when running is more than likely an output for a transonder key interface or a third ign wire, which you shouldnt need but without knowing more about what your trying to install its hard for us to help

Back to Top

49 chevy guy

Member - Posts: 2

Joined: January 06, 2010

Location: Kansas, United States

Posted: January 09, 2010 at 2:11 PM / IP Logged

i did find out that the neg. when running is an output for a transponder key interface. thank you guys, sorry for being so vague but that is all the instructions said it was. the system is an xtreme xr-22 remote start with keyless entry. it does work now, i just have to try and figure out how to wire in the running/parking lights.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

remote starter wiring

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.