2010 mazda 3 wont unlock?

i did a autopage rs603 remote start keyless entry on a 2010 mazda 3 without smartkey and the only issue is when you go to unlock it after remote start the unit will chirp twice but doesnt unlock the doors but it unlocks with the car not remote started everytime without issues i used the green wire at bcm for locks with the resistor and relays. any ideas?

After reading through the tech sheet, I have a couple of questions before trying to tackle your issue. First, you only have the resistor on the lock relay, correct? The sheet says lock is through a 1K resistor but unlock is straight ground. Are you on the light green wire or the green wire? According to the tech sheet the green wire is what controls the factory alarm, and the light green controls the locks. In my experience with Mazda's the factory alarm disarm wire will unlock the doors with a second pulse. Have you tried setting the disarm pulses to 2? How about setting the unlock pulses to 2?Installer, IT support, and FFL. I need less hobbies.

yes i have the correct wire and have the resistor on the lock wire. as i stated before it works correctly lock and unlock until the car is remote started once the car is remote started it wont unlock the doors.