Newbie question

well i can tell you from my installer view. cross out the Black Widow. they are about as reliable as far as i could throw them. here's the wiring diagram: 12volts      yellow & lt. grn/pur      +   ignition harness Starter          WHITE/ pink           +   ignition harness Ignition     RED / lt. green      +   ignition harness Second      gray / YELLOW        +   ignition harness Ignition      Accessory   BLACK/ lt. green      +   ignition harness Second        RED / black      +   ignition harness Accessory Power Lock     lt. green      +   low in drivers kick or Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column. Power Unlock      purple      +   low in drivers kick or Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column. Parking Lights+        brown   light switch or drivers kick Parking Lights-        WHITE/ black            Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column. Door Trigger          -       Notes: There are two door trigger wires. Use yellow/black for the drivers door and gray/red for the passengers door. Both wires are found above the drivers kick panel in a 20 pin connector. Use both wires and diode isoate each. See direct fax document #1076 for wiring information. Dome Supervision   BLACK/ white +   drivers kick panel or Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column. Trunk/Hatch Pin     BROWN / white      -   drivers kick panel or Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column. Trunk/Hatch     purple / YELLOW      +   drivers kick panel Release Factory Alarm    dk. GREEN/ purple - drivers kick panel Disarm or      Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column.                 Tachometer                Notes: For the 3.8L motor, use the dk. blue/lt. green, RED / lt. blue, or the pink/white. All of these wires are found at the coil pack. The 4.6L motor uses a separate coil for each cylinder. Go to any coil and use the wire that is NOT red or WHITE/ lt. blue. Brake Wire     RED / lt. green      +      brake switch Horn Trigger     yellow/lt. green - steering column or Notes: Also found at the GEM module located above the drivers kick panel to the drivers side of the steering column. Immobilizer By Pass : This vehicle has the PATS anti-theft system. Use DEI part number 555F to bypass during remote start operation. Sorry to make it so long.

sorry it double posted

From those three, I'd choose the Prestige unit. I recently installed a Mannix for a friend who bought it off eBay, and the install manual is full of typo's. And the parts they corrected, they put a sticker over. I'd also consider the Hornet 554T, Clifford RS3, Viper 790XV, or Python 880XP (all made by DEI).Friends Don't Let Friends Bump Stock.

if your looking for something other than those three than look at the Marksman M10. i love mine. temp gauge, knock sensor, etc....

The Prestige APS996 or any of the DEI products. The Prestige is fairly easy to install and it comes with 2 remotes, 1 lcd and a regular remote.Tacomacrew