96 taurus remote start

I installed a Phonics Digital Remote Start in my 96 Taurus GL this weekend with little sucess.

I was able to get the remote lock & unlock to work but after I get in the car and start the engine, the alarm still beeped after about 1 minute.

The car will crank but not start, I did smell gas so all I can figure is there was no spark. I tried to confirm with the system that it was sensing the tach but I don't think it did. I hooked my tack wire up to the yellow/white wire on coil per the instructions i found here.

Also, there is a wire on the alarm system that is for 'Positive 12v at key cylinder during on and crank' where is this supposed to be hooked up to? The Battery?

I have installed a few remote starts but have not had problems like this before, should I throw it in the gutter and go buy another?

Thanks for your help.

I hooked that wire to one of the wires on the ignition switch but believe i may have used the wrong one. My car does not have a factory alarm and I am pretty sure it doesn't have a factory immobilizer. The Phonics system sounded like it was rearming itself, the siren chirped and the lights flased 4 or 5 times.