2011suburban 4x4 5.3l

I am looking for anything, diagrams/guides to help me install a remote start & security system. 

I am also looking for general wiring diagrams for the vehicle including the head and tail lights, etc...

Thanks you,

Scott

This is for a 2010 but it should be close            #82117: 2010 CHEVROLET SUBURBAN 4DR SUV WITH 5.3L ENGINE AND BOSE ® AUDIO SYSTEM Security                                              WIRE          COLOR          POLARITY          LOCATION      Battery          RED / BLACK          (+)          AT VEHICLE FUSE BOX      Ignition 1          PINK          (+)          IGNITION SWITCH HARNESS      Starter 1          YELLOW/BLACK          (+)          AT ECM MODULE BEHIND DRIVER HEADLIGHT      NOT FOR REMOTE START      All Door Trigger          GRAY/BLACK          (-)          AT COURTESY LIGHT UNDER DASH      SOME VEHICLES MAY NOT BE EQUIPPED WITH THIS LIGHT, IN THIS CSE YOU MUST USE ALL FOUR DOOR TRIGGERS AND DIODE ISOLATE EACH WIRE      Domelight Super          GRAY          (+)          AT BCM MODULE UNDER DRIVER DASH      LF Latch          BROWN          (-)          AT DRIVER DOOR MODULE IN DRIVER DOOR      RF Latch          BLACK/ WHITE          (-)          AT PASSENGER DOOR MODULE IN PASSENGER DOOR      MAY ALSO BE TAN/WHITE ON SOME MODELS      LR Latch          LIGHT BLUE/BLACK          (-)          AT BCM MODULE UNDER DRIVER DASH      PLUG C6 PIN 15      RR Latch          LIGHT GREEN/ /BLACK          (-)          AT BCM MODULE UNDER DRIVER DASH      PLUG C6 PIN 14      Trunk Trigger          PINK/BLACK          (-)          AT BCM MODULE UNDER DRIVER DASH      MAY ALSO BE AT LIFTGATE MODULE IN LEFT REAR QUARTER PANEL IF EQUIPPED WITH POWER HATCH      Hood Trigger          PINK/BLACK          (-)          AT BCM MODULE UNDER DRIVER DASH      Alarm Disarm          LIGHT GREEN          (-)          AT MODULE IN DRIVERS DOOR      Parking Lights          LIGHT BLUE          (-)          AT BCM MODULE UNDER DRIVER DASH      Data Bus          DARK GREEN          (DATA)          AT OBD2 PLUG      Convenience                                              WIRE          COLOR          POLARITY          LOCATION      Headlights-Lo          WHITE          (-)          AT BCM MODULE UNDER DRIVER DASH      MAY BE PINK/WHITE      Headlights-Hi          TAN/WHITE          (-)          AT BCM MODULE UNDER DRIVER DASH      LF Pk Lt Bulb          BROWN          (+)          AT FRONT LEFT PARKING LIGHT      RF Pk Lt Bulb          BROWN          (+)          AT FRONT RIGHT PARKING LIGHT      LR Pk Lt Bulb          BROWN          (+)          AT REAR LEFT PARKING LIGHT      RR Pk Lt Bulb          BROWN          (+)          AT REAR RIGHT PARKING LIGHT      All Hazrd Lights          WHITE          (-)          AT VEHICLE HAZARD SWITCH      LF Hazrd Bulb          LIGHT BLUE/WHITE          (+)          AT FRONT LEFT TURN SIGNAL LAMP      RF Hazrd Bulb          DARK BLUE/WHITE          (+)          AT FRONT RIGHT TURN SIGNNAL LAMP      LR Hazrd Bulb          YELLOW          (+)          AT REAR LEFT TURN SIGNAL LAMP      RR Hazrd Bulb          YELLOW          (+)          AT REAR LEFT TURN SIGNAL LAMP      Wipers-Lo          GRAY          (+)          AT BCM MODULE UNDER DRIVER DASH      Wipers-Hi          TAN          (-)          AT BCM MODULE UNDER DRIVER DASH      Parking Brake          LIGHT BLUE          (-)          AT VEHICLE PARKING BRAKE SWITCH      Trnk Release          PINK OR GRAY          (-)          AT BCM MODULE UNDER DRIVER DASH      PINK IS GLASS RELEASE, GRAY IS HATCH RELEASE      Seat Mem 1          ORANGE          (+)          AT DRIVER DOOR MODULE IN DRIVER DOOR      MUST USE (+) THROUGH A 2.2K OHM RESISTOR      Seat Mem 2          ORANGE          (+)          AT DRIVER DOOR MODULE IN DRIVER DOOR      MUST USE (+) THROUGH 4.2K OHM RESISTOR, SAME WIRE AS DRIVER SEAT MEMORY 1      Remote Start                                              WIRE          COLOR          POLARITY          LOCATION      Battery          RED / BLACK          (+)          AT VEHICLE FUSE BOX      Ignition 1          PINK          (+)          IGNITION SWITCH HARNESS      Ignition 2          WHITE          (+)          IGNITION SWITCH HARNESS      Accessory 1          BROWN          (+)          IGNITION SWITCH HARNESS      MAY ALSO BE YELLOW ON SOME MODELS      Starter 1          YELLOW/BLACK          (+)          AT ECM MODULE BEHIND DRIVER HEADLIGHT      NOT FOR REMOTE START      Starter 2          WHITE          (+)          IGNITION SWITCH HARNESS      USE A 1.3K OHM RESISTOR FOR STARTER,      Anti-Theft Type          GM PASSKEY III® ANTI-THEFT SYSTEM      Anti-Theft Descript          THE KEY SENDS AN RF SIGNAL TO THE BCM MODULE THROUGH AN ANTENNA LOCATED AROUND THE IGNITION CYLINDER      Key Sense          PINK          (+)          IGNITION SWITCH HARNESS      MUST USE FOR REMOTE START      Tachometer          TAN          (AC)          AT ECM MODULE BEHIND DRIVER HEADLIGHT      Crankshaft Sensor          WHITE/ BLACK          (AC)          AT ECM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD      PLUG C2 - PIN #68      Camshaft Sensor          DARK BLUE/WHITE          (AC)          AT ECM MODULE BEHIND DRIVERS SIDE HEADLIGHT UNDER HOOD      PLUG C2 - PIN #64      Speed Sense          YELLOW/BLACK          (AC)          AT ECM MODULE BEHIND DRIVER HEADLIGHT      Parking Lights          LIGHT BLUE          (-)          AT BCM MODULE UNDER DRIVER DASH      Brake Lights          LIGHT BLUE/WHITE          (+)          AT SWITCH ABOVE BRAKE PEDAL      Reverse Lights          DARK BLUE          (+)          AT BCM MODULE UNDER DRIVER DASH      Horn          TAN          (-)          AT BCM MODULE UNDER DRIVER DASH      Modules                                              WIRE          LOCATION                          Module 1          BCM MODULE - UNDER DRIVER SIDE OF DASH TO LEFT OF STEERING COLUMN      Module 2          ECM MODULE - UNDER LEFT SIDE OF ENGINE COMPARTMENT NEAR FAN SHROUD      Doorlocks/Windows                                              WIRE          COLOR          POLARITY          LOCATION      Databus Wire          DARK GREEN          (DATA)          AT OBD2 PLUG      Power Unlock          WHITE          (-)          AT BCM MODULE UNDER DRIVER DASH      THIS WIRE WILL UNLOCK THE REAR DOORS AND THE HATCH, MUST USE REVERSE POLARITY IN EACH FRONT DOOR FOR UNLOCK WITH OUT INTERFACE MODULE      PowerLock          LIGHT BLUE          (+)          AT BCM MODULE UNDER DRIVER DASH      THIS WIRE WILL LOCK THE REAR DOORS AND THE HATCH, MUST USE REVERSE POLARITY IN EACH FRONT DOOR FOR LOCK WITH OUT INTERFACE MODULE      Driver Mtr Unlock          TAN          (REV)          AT MOTOR IN DOOR      Driver Mtr Lock          VIOLET          (REV)          AT MOTOR IN DOOR      Pas Mtr Unlock          TAN          (REV)          AT MOTOR IN DOOR      Pas Mtr Lock          GRAY/BLACK          (REV)          AT MOTOR IN DOOR      LF Window Up          BLUE          (AC)          AT DRIVER WINDOW SWITCH IN DRIVER DOOR      LF Window Dn          BROWN          (AC)          AT DRIVER WINDOW SWITCH IN DRIVER DOOR      RF Window Up          BLUE          (AC)          AT PASSENGER WINDOW SWITCH IN PASSENGER DOOR      RF Window Dn          BROWN          (AC)          AT PASSENGER WINDOW SWITCH IN PASSENGER DOOR      LR Window Up          BLUE          (AC)          AT REAR LEFT WINDOW SWITCH IN REAR LEFT DOOR      LR Window Dn          BROWN          (AC)          AT REAR LEFT WINDOW SWITCH IN REAR LEFT DOOR      RR Window Up          BLUE          (AC)          AT REAR RIGHT WINDOW SWITCH IN REAR RIGHT DOOR      RR Window Dn          BROWN          (AC)          AT REAR RIGHT WINDOW SWITCH IN REAR RIGHT DOOR      Sunroof Open          BROWN          (-)          AT SUNROOF CONTROL SWITCH      Sunroof Close          ORANGE          (-)          AT SUNROOF CONTROL SWITCH                          Note: Code Systems makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Code Systems disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.If i Can't Install it    I Don't need it   Joe

Thank you!