2005 altima remote start

I am installing a Astra 4000rs Security and remote start system along with Xpresskit Solex Series XK09 bypass module in a 2005 Nissan Altima.  I have the system wired in and have double checked all wires.  Flashed the module for door lock and immobilizer.  Programmed module while in car. Everything has been successful except for the fact that nothing will work.  Door locks, trunk release will not respond at all.  Remote start will turn the car engine over but will not start.  I have tried to diagnose through the LED diagnostics, but everything checks out fine.  Like I said, I double checked the wires but if you think that is the problem, I will double check again.  I have no idea where to go from here.  I have researched the internet and cannot find a solution.  If anyone has any suggestions, PLEASE respond.  Thank you in advance for your help and advice.Thanks

Cody J Smith

Did you solder your connections? I would start by disconnecting the XK09, put a key in the ignition in the off position and try remote starting the car. This will verify that all of your remote starter connections are fine and the only problems lie with the bypass. Installer, IT support, and FFL. I need less hobbies.

I did solder all conection. I took your advice and removed the modual and tryed it with the key in the ignition and  everything worked fine with the remote start. So im guessing that i have got a hold of a bad modual. I also volt metered the can bus high/low wires with the mod hooked up while trying to unlock the doors with after market system and saw no voltage change but when i metered them while using the stock keyless entry they gain volts when pressing the unlock/lock buttons. Anyone with input is welcome. Thank you.Thanks

Cody J Smith