astra 4000rs 2w 1, 1998 s10 pickup

Hi How do I install a ASTRA 4000RS-2W-1 into my 1998 S10 extended cab pickup?

What exactly are you asking? If you need a wiring diagram take a look through the 'vehicle wiring' link at the top of this page. Do you have a bypass module or do you plan on using resistors/relays? If you are not familiar with electronics, and specifically vehicle electronics, I would strongly recommend paying a professional to install it for you. Saving yourself a few dollars by installing it yourself could wind up costing you big money if you need to have your vehicle repaired.Installer, IT support, and FFL. I need less hobbies.

What color Wirs to what whirs?

I will be using resistors/relays.

I have a 1998 s10 pickup what color wires to what astra 4000rs color wires?

                  #60257: 1998 CHEVROLET S-10 PICKUP EXTENDED CAB TRUCK Security                                              WIRE          COLOR          POLARITY          LOCATION      Battery          RED          (+)          IGNITION SWITCH HARNESS      Ignition 1          PINK          (+)          IGNITION SWITCH HARNESS      Starter 1          YELLOW          (+)          OR VIO IGN SWITCH HARNESS      All Door Trigger          WHITE          (-)          COURTESY LIGHT OR AT BCM TAN DR.+ ORG PA      Parking Lights          BROWN          (+)          AT LIGHT SWITCH OR LTBLU PLUG AT BCM      Convenience                                              WIRE          COLOR          POLARITY          LOCATION      Headlights-Lo          VIOLET/WHITE          (-)          VIO PLUG AT BCM      LF Pk Lt Bulb          BROWN          (+)          AT FRONT LEFT PARKING LIGHT      RF Pk Lt Bulb          BROWN          (+)          AT FRONT RIGHT PARKING LIGHT      LR Pk Lt Bulb          BROWN          (+)          AT REAR LEFT PARKING LIGHT      RR Pk Lt Bulb          BROWN          (+)          AT REAR RIGHT PARKING LIGHT      Wipers-Lo          VIOLET          (+)          AT LIGHT SWITCH      Trnk Release          BLACK          (+)          AT SWITCH      Remote Start                                              WIRE          COLOR          POLARITY          LOCATION      Battery          RED          (+)          IGNITION SWITCH HARNESS      Ignition 1          PINK          (+)          IGNITION SWITCH HARNESS      Ignition 2          BROWN          (+)          IGNITION SWITCH HARNESS      Ignition 3          WHITE          (+)          OR PNK/WHT IGN HARNESS (TRANSMISSION)      Accessory 1          ORANGE          (+)          IGNITION SWITCH HARNESS (HEAT/A.C.)      Starter 1          YELLOW          (+)          OR VIO IGN SWITCH HARNESS      Anti-Theft Type          RESISTOR BASED SYS      Anti-Theft Descript          PASSLOCK II      Key Sense          LIGHT GREEN          (-)          STEERING COLUMN HARNESS      Neutral Safety          NOT GRDING      Tachometer          WHITE          (-)          AT COIL TOP OF ENG PASS SIDE      Speed Sense          GREEN / WHITE 4000          (AC)          PASS FRT QTR BLK 80 PIN CONN POS 16      Parking Lights          BROWN          (+)          AT LIGHT SWITCH OR LTBLU PLUG AT BCM      Brake Lights          LIGHT BLUE          (+)          AT BRAKE SWITCH      Reverse Lights          GRAY          (+)          AT SWITCH ON TRANSMISSION      Horn          BLACK          (-)          BRN PLUG AT BCM      Modules                                              WIRE          LOCATION                          Module 1          TO RIGHT OF GAS PEDAL BELOW RADIO      Doorlocks/Windows                                              WIRE          COLOR          POLARITY          LOCATION      Power Unlock          WHITE          (+)          POSITIVE TRIGGER      PowerLock          LIGHT BLUE          (+)          DRIVERS KICK PANEL OR BRN PLUG AT BCM      LF Window Up          DARK BLUE      LF Window Dn          BROWN      RF Window Up          LIGHT BLUE      RF Window Dn          TAN             If i Can't Install it    I Don't need it   Joe

astra 4000rs color wires?

Sorry I don't have those wire hopefully someone will. The kit didnt come with an install guide ?If i Can't Install it    I Don't need it   Joe

http://www.scytek.net/manuals/astra/a4000rs.pdf Violet - Starter Out 25 Amp. (+) Red - +12V Battery Input #1 Red - +12V Battery Input #2 Brown - Ignition 2 Output 25 Amp. (+) Yellow- Ignition 1 Out 25 Amp. (+) Orange- Accessory Out 25 Amp. (+) BROWN / White - Horn Output (-) BLACK/ Gray - Tach Input (RPM Input) Brown - Siren Output 3Amp (+) Green - Negative Door Input (-) Violet - Positive Door Input (+) Pink -             Factory Rearm Out (-) 500ma WHITE/ Black - Hood Pin Input (-) Black - Sytem Ground (-) BLACK/ White - Dome Light Out (-) 500ma WHITE/ Violet - Factory Disarm Out (-) 500ma Blue/Orange - Ground When Running Out(-) 500ma Orange - Anti-Grind Out (-) 500ma Gray - Trunk Release Out (-) 500ma GREEN / WHITE - Brake Input (+) White - Parking Light Out (+/-) Red - +12V Input (+)

6-Wire Starter Harness Pin 1 RED -   A: Main Power Input A (+). Connect to the battery or constant power wire at the ignition switch with a minimum 30 Amp supply. Remove the fuse until the installation is complete and all wiring is checked. Pin 2 RED -   B: Main Power Input B (+). Connect to the battery or constant power wire at the ignition switch with a minimum 30 Amp supply. Note: if connecting at the ignition switch it is highly recommended to use separate power wires for each Red wire, each with a minimum 30A supply. Remove the fuse until the installation is completed and all wiring is checked. Pin 3 BROWN: Second Ignition Output (+). The Brown wire provides +12V for a second ignition wire. This wire may instead be programmed for use as a second accessory or second starter wire. Pin 4 ORANGE: Accessory Output (+). Connect to the accessory wire coming from the ignition switch that supplies power to the heater/air-conditioner. Some cars may have multiple accessory wires. Pin 5 YELLOW: Ignition Output (+). Connect to the main ignition wire that provides +12V when the ignition is on and while cranking the starter. Pin 6 VIOLET: Starter Output (+). Connect to the the vehicle’s starter wire. 16-Pin Main Harness Pin 1 BROWN / WHITE: Horn Output (-) 500 mA. Connect to a relay to activate the vehicle’s horn when the alarm is triggered. Pin 2 BLACK/ GRAY: Tach Input. Connect to the vehicle’s tach wire or a fuel injector wire if the tachless mode does not provide satisfactory operation. Pin 3 BROWN: Siren Output (+) 3A. The Brown wire must connect to the siren’s red wire. The Black siren wire must be grounded. Pin 4 GREEN: Negative Door Input (-), Connect to the door switch circuit wire that shows ground when the door is open. Pin 5 VIOLET:Positive Door Input (+), Connect to the door switch circuit wire that shows +12V when the door is open. This type of door circuit is usually found on Ford vehicles. Pin 6 YELLOW : Factory Rearm (-), this wire will pulse negative upon remote start shut down. Pin 7 WHITE/ BLACK: Hood Pin Input (-). Connect the to the hood pin switch. The switch must provide a ground output when switch is opened. Pin 8 BLACK: Ground Input (-), The Black wire must connect to a solid chassis ground. Clean away any paint or dirt to insure the best possible ground.    Pin 9 BLACK/ WHITE: Dome Light Output (-) 500 mA. Connect to the wire that activates the vehicle’s dome light, usually the door pin switch wire. (see Green and Violet door trigger wires). Note: Must Use Relay. Pin 10WHITE/ VIOLET: Factory Disarm Output (-) 500 mA. The Violet/white wire provides a ground output on disarming and before remote starting to disarm a factory security system. Connect to the wire that requires a ground pulse to disarm the factory security system. Pin 11BLUE/ORANGE: Ground When Running Output (-) 500 mA. Connect to an optional factory security bypass module if required. Pin 12ORANGE: Armed Output (-) 500 mA. The Orange wire provides a ground output while armed to activate a relay for starter defeat and anti-grind protection.