the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

power door lock recommendation


Post ReplyPost New Topic
< Prev Topic Next Topic >
dadtruck 
Member - Posts: 29
Member spacespace
Joined: August 27, 2009
Location: Indiana, United States
Posted: July 31, 2012 at 12:37 PM / IP Logged  

 I want to install power door locks as part of a re build project on a 1983 D-150. It is a two door so and I am likly going to install a single actuating switch towards the center of the dash to lock and un lock both doors,,

looking at universal kits on line,, seen then as cheap as 31.95 on Amazon

http://www.amazon.com/Universal-Central-Unlock-Conversion-actuators/dp/B0033YECEK/ref=sr_1_1?ie=UTF8&qid=1343755440&sr=8-1&keywords=power+door+lock+kit+2+door

or at around 95.00 also on Amazon,

http://www.amazon.com/AutoLoc-CK2000-Door-Remote-Central/dp/B000CIFN9I/ref=sr_1_4?ie=UTF8&qid=1343755776&sr=8-4&keywords=power+door+lock+kit+2+door

I don't mind paying for good quality,, but I don't want to just throw $ away either,,I have also seen kits on the internet for almost 200.00

1) any recommendations?

2) also do I need to select anything special for the power door lock system, if I want to also wire in an alarm,, There was an older viper unit on the truck and I plan to re install it.

3) and a back to the added dash switch,, can that be done with a Central Locking unit?

thanks

DadTruck
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: July 31, 2012 at 4:16 PM / IP Logged  
The best kit is a prewired 2 actuator system with a dedicated relay* and wire the driver's door ONLY as a 5 wire.
* The dedicated relay has built in timers and (-) NEG switching extra triggers thus compatible with nearly all alarms.
You need a dedicated timer if you're setting up a 5 wire otherwise the relay stays latched, thus burnt out motors and a flat battery.
You should look also at MES (the best, sold by DEI) and Spal, both good quality prewired kits.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: July 31, 2012 at 4:19 PM / IP Logged  
I thought the prices quoted were rather expensive, they come with a remote control, i.e they are keyless entry + c/lock conversion kits. If you already have an alarm the keyless entry part isn't required.
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: July 31, 2012 at 4:21 PM / IP Logged  
On your second link, look down to the Crimestopper 2 motor kit at around $25.
smokeman1 
Platinum - Posts: 1,588
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: September 14, 2009
Location: Wisconsin, United States
Posted: July 31, 2012 at 7:44 PM / IP Logged  

I bought a universal keyless entry kit for my work van, (company is kind of anal about locking the van but won't buy a vehicle with power locks) But I digress.

Bought it on E-Bay, (sorry Howie), for about 32 bucks. Been working fine for three years now, even intergrated it into my Viper 5701 system via a 451m.

I lock/unlock this truck 20-35 times a day.   Biggest tip is to secure the accuators soildly to the door.  I didn't on the side door and back door of the van and had to redo them as the accuator would flex away and not pull the rod is a straight line.  It was my first lock install, so I learned. Did much better on other installs. 

Bolt the accuators solidly and bend the rod to match the pull of the lock rod.  Anyway, thats my experience and two cents.

When all else fails, Read the Instructions
Support the12volt.com Make a Donation
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: August 01, 2012 at 12:21 AM / IP Logged  
Smokeman...
Your last sentence bar 1 bolt the actuators securely and bend the rod to match the pull of the lock rod.
O.K., I changed one word but that sentence is the be-all and end all of installing them except the second line, which should read make sure actruator movement and its wiring clears all other moving parts.
smokeman1 
Platinum - Posts: 1,588
Platinum spaceThis member has made a donation to the12volt.com. Click here for more info.spaceThis member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.spacespace
Joined: September 14, 2009
Location: Wisconsin, United States
Posted: August 01, 2012 at 5:46 AM / IP Logged  

Good thoughts...I shouldn't be typing and watching the olympic swimsuit and womens beach vollyball contest at the same time

When all else fails, Read the Instructions
Support the12volt.com Make a Donation
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: August 01, 2012 at 8:10 AM / IP Logged  
I also spelt actuator wrong because with me it was the women's beach volleyball and foot ball those 2 and men's football are the only events I watched.
Trouble was the women footballers don't seem to follow one men's idea where you swap shirts at the end of internationals.
dadtruck 
Member - Posts: 29
Member spacespace
Joined: August 27, 2009
Location: Indiana, United States
Posted: November 24, 2012 at 7:49 PM / IP Logged  

Hello,, late last summer I had put up a post asking about powered door locks,,

thanks for the info,, I have some free time coming the next couple of weeks so I got back to the shopping process..

I ended up going with the A1 Electronics W01F-74OT, which is a MES Central Lock with a 3100 Avilatar alarm,, the claimed regular price is 168,, on sale fpr 134 and currently offfered with a 5% disciunt and free shipping,, so going for 128,,, seemed like a good deal, so I went for it.  Having an integrated alarm will certainly save me some install figuring and time. I am pretty good mechanically,, working on figuring out electronics,, I'll post back on how the install went..

DadTruck
howie ll 
Pot Metal - Posts: 16,466
Pot Metal spacespace
Joined: January 09, 2007
Location: United Kingdom
Posted: November 24, 2012 at 7:55 PM / IP Logged  
MES are the best you can get, the 3100 is DEI's basic entry level. It works but it's very, very basic.
Incidentally, sold over here as a Viper 3100 power door lock recommendation -- posted image.
Last year they called it an Avital.
Same product anyway.

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, May 7, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer