2006 toyota tacoma doorlocks

Supposed to be in the connector going to the driver door, GREEN/ black unlock and purple lock. I found the wires but they seem to rest at NEG all the time and I see no change when I cycle the key in the drivers doorlock or if I feed them negative pulses. I did a search and found a few references to a possible blue/white and grey wire in the same area of the truck. I installed an Avital 4113 remote start with a xk05 module and would like the door to unlock while under remote start. I know somebody has an answer. BTW if you use the xk05 with the 1.02 firmware in D2D mode you MUST hook the brown ground input wire to a status wire on the remote starter even though DEI's wiring chart shows its not needed.

Power Lock      blue/white      -      driver kick, white 10 pin plug, pin 6 Notes: This wire is only needed if the door locks do not function with the aftermarket system while the vehicle is running. All other times just use the factory alarm arm wire. Power Unlock      gray      -      driver kick, white 10 pin plug, pin 7 Notes: This wire is only needed if the door locks do not function with the aftermarket system while the vehicle is running. All other times just use the factory alarm disarm wire. Factory Alarm Arm      purple (driver door key cylinder lock)      -      driver kick, white 10 pin plug, pin 4 Factory Alarm Disarm      GREEN/ black (driver door key cylinder unlock)      double -      driver kick, white 10 pin plug, pin 8

Thank you! ......Its strange I couldnt get the purple or GREEN/ black to do anything, running or not.