2006 altima avital 4103 dball

hey guys i need your help i have 2006 altima it has second starter wire which i used relay to hook up but for some reason the remote starter keep trying to crank the car but it wont start after several times the module just died no power or flashing light not even sending power to xpresskit dball either i checked incoming 12v they are fine what could be the problem?

Sorry but why the DB-ALL? A simple by-pass such as a 556U would have sufficed.

with db all i dont have to hook up door status wires its less wiring to deal with

Yes and costs 3 times as much, especially on a simple vehicle with no installation "nasties" such as having to wire inside the doors. Also, I bet you did it D2D mode which is actually less reliable and harder to trouble shoot. Any way use the wiring template post on this page and let's see what you've connected to where please.

Kind of hard to read your post since you didn't bother with punctuation. I would try to get the remote starter working with a good key in the ignition, in the Off position, and then worry about the DBALL part after you get the car to start. Also, what is the date code on the white sticker on the 4103, and was the installation guide a small book, or a large, fold-out sheet of paper? If the guide is a small book, and the date cold is older, DEI shipped those units out with a defective data port. You'd have to swap it out for a newer one, or go wire-to-wire, unfortunately.

Chris, looking again at the OP's syntax, I'm guessing the writer has an excuse, Russian being his/her first language. If not; in my experience the better the spelling the better the installer. If you aren't careful enough or take the time to write properly, what's your install like?