06 kia spectra alarm door lock relay

My wife owns a 06 Kia spectra5 and it has been alot of years since I have installed alarm, in fact the last one I did was my 79 Corvette with power door locks and power windows and used relays for the corvette but I can not remember how to wire up door locks. I have relays and need to figure out how to wire 2 relays to the door lock and unlock wires, I know the color codes to use which I found on this forum but do not have the relay wiring and which wire goes to 12 volt hot,ground and which one goes to lock and unlock wires is there a diagram we can follow

This web site has those diagrams... https://www.the12volt.com/doorlocks/page3.asp#5w There are all the types of diagrams you would need. If you are using two relays, it should be the diagram for the 5 wire set up. When I did my 2000 Kia Sephia, I added an aftermarket actuator to the drivers door, and that actuated the other locks to either lock or unlock. The tech sheet says: Power Lock     yellow/orange      -     driver kick, door harness      Power Unlock     yellow/black      -     driver kick, door harness      You should be able to apply a negative output from the alarm to these wires and it will actuate the lock or unlock feature. YOu should not need relays for this install. I hope this helps. Thanks,

Mike Ward

Get it done right the first time!

So I am guessing the factory default from the 2 wires or blue and green are postive output and I need to make them negative output correct?