Here is the wiring going by the ReadyRemote wire listing. You should check / verify all wires prior to making connections.
H1/1 RED (+) 12V CONSTANT INPUT BLACK/ white to white (50A) (+) @ ignition switch, blue 4 pin plug, pin 1
H1/2 BLUE (-) 200 mA SECOND UNLOCK OUTPUT yellow/red (all doors) @ BIU, gray 20 pin plug, pin 11
H1/3 BLACK/ WHITE-1 INPUT OF DOMELIGHT SUPER chassis ground
H1/4 BLACK/ WHITE OUTPUT OF DOMELIGHT SUPER blue (-) @ BIU, gray or blue 16 pin plug, pin 5
H1/5 GREEN/ BLACK LOCK #30 COMMON OUTPUT RED / white (-) @ BIU, gray 20 pin plug, pin 12
H1/6 WHITE/ BLACK LOCK #87 NORMALLY CLOSED not used
H1/7 VIOLET/BLACK LOCK #87 NORMALLY OPEN (IN) chassis ground
H1/8 BLUE/BLACK UNLOCK #30 COMMON (OUTPUT) ORANGE / black (driver door) (-) @ BIU, gray 20 pin plug, pin 14
H1/9 VIOLET UNLOCK #87 NORMALLY OPEN (INPUT) chassis ground
H1/10 WHITE (+/-) PARKING LIGHT FLASH OUTPUT orange (+) @ parking light switch, white 4 pin plug, pin 4 ***Set to +
H1/11 BLACK (-) CHASSIS GROUND INPUT chassis ground
H1/12 BROWN (-) HORN HONK OUTPUT GREEN/ red to RED / green (-) @ horn switch, black 5 pin plug, pin 1
H1/13 LT. GREEN/ BLACK FACTORY ALARM DISARM not used
H1/14 WHITE/ BLUE (-) 200 mA CHANNEL 3 OUTPUT not used
H1/15 YELLOW (+) SWITCHED IGNITION INPUT black to green (+) @ ignition switch, blue 4 pin plug, pin 4
H1/16 ORANGE (-) 500 mA GROUND-WHEN-ARMED OUT not used / or starter kill or window roll-up, etc
H1/17 BROWN / BLACK UNLOCK #87A Not Used
H1/18 RED / WHITE (-) OUTPUT OF CHANNEL 2 yellow/red (sedan only) (-) @ Keyless Entry Module above dash fuse box, white 16 pin plug, pin 6
If you don't want priority door unlock feature, H1/2 not used and yellow/red (all doors) to H1/8 instead of ORANGE / black (driver door).
H1/18 is trunk release for sedans, hatch opens with locks.
Ensure Parking Light jumper is set to (+).
If you want Starter Kill, obtain a 30/40Amp SPDT relay and wire as follows :
Relay Pin 87a to key side of cut starter wire ( BLACK / YELLOW to WHITE/ black (+) @ ignition switch, blue 4 pin plug, pin 3 )
Relay Pin 30 to vehicle side of cut starter wire ( BLACK / YELLOW to WHITE/ black (+) @ ignition switch, blue 4 pin plug, pin 3 )
Relay Pin 87 not used - insulate
Relay Pin 86 to H1/15 ( with black to green (+) @ ignition switch, blue 4 pin plug, pin 4 )
Relay Pin 85 to H1/16
Soldering is fun!