2008 lancer, std key, manual transmission

Home / the12volt's Install Bay / Car Security and Convenience / 2008 lancer, std key, manual transmission (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

nhampto2

Member - Posts: 14

Joined: December 05, 2012

Location: Alberta, Canada

Posted: October 12, 2013 at 7:58 PM / IP Logged

I had a 2008 Lancer to install a starter in. Manual transmission. Used a CM6200.Â Using a Blade-AL flashed with MI-2.

Install is easy enough on this vehicle. Problem no is it work go into reservation mode. Take the key out, engine stays running, good. Exit the vehicle and close the door and engine turns off, good. But that's as far as it goes. Doors do not lock. Starter is not in reservation.

Any ideas?

Back to Top

nhampto2

Member - Posts: 14

Joined: December 05, 2012

Location: Alberta, Canada

Posted: October 12, 2013 at 8:01 PM / IP Logged

Sorry for spelling/bad grammar in OP... Posting on my phone.

Also to add, locks are working when manually commanding from the remote.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2008 lancer, std key, manual transmission

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.