Compustar Remote Start, Security, EZGO

Home / the12volt's Install Bay / Car Security and Convenience / Compustar Remote Start, Security, EZGO

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

jake1959

Member - Posts: 1

Joined: October 27, 2015

Location: Pennsylvania, United States

Posted: October 27, 2015 at 8:04 PM / IP Logged

My car is 2016 Subaru Legacy. I had the MaxIt FT-7000AS with RF-P2W902-SS and EZGO installed. The 2 things I don't like about the system is #1.When I remote start the car and walk up to it the Ezgo will not unlock the doors automatically. I have to press a button to unlock the doors. #2 is even more annoying. If I use the button that is on factory key to unlock the doors the alarm goes off when I open the door. Is this the way the system is supposed to work? What if I go away and the Compustar remote stops working. I could use the button on the factory key but then the alarm go off. That's not good. Any suggestions? Thank You

Back to Top

rs specialist

Copper - Posts: 175

Joined: September 30, 2015

Location: Arizona, United States

Posted: October 29, 2015 at 6:53 PM / IP Logged

Did you install the system yourself? If not i would take the vehicle back to the installation facility and have them correct that as there is a way to have the EZGO unlock and lock. As for the factory keyfob setting off the alarm, that is because the Compustart is not monitoring the OEM keyless signal. I haven't done that specific vehicle so I can not say if the compustar will do that or not. I assume that was the reasoning for the EZGO in the first place.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.