Compustar cm7000 False Alarms

Vehicle: 2015 Jeep Wrangler Alarm: (New-Install) Compustar cm7000as w/2W704r-sh long range 2-way RF transmitter Bypass Module: Fortin EVO-ALL The only wiring done outside the CAN-BUS are parking lights, siren, hatch trigger and 12v switched connections. - Doors triggers are connected through CAN-BUS; hood and hatch triggers are hard-wired into Jeep. - Compustar DAS Tilt/2-stage shock Sensor is currently DISCONNECTED from the brain. - DEI Proximity Sensor is currently DISCONNECTED from the brain. About 20% of the time my Compustar will go into full alarm within 5 seconds of arming the system. I thought the issue might have been the proximity sensor so I disconnected it completely. When that didn't work, I also disconnected the DAS tilt/shock sensor with no change (currently no external sensors are connected). After going into full alarm, pressing disarm turns off the siren but the parking lights continue to cycle through the full timeout period of 30 secs and the doors do not unlock. If I hit disarm a second time, the trigger cycle stops and the doors unlock but there are NO zone breaches indicated on the 2-way remote, by parking light or LED flashes as if the alarm never went off. When the alarm triggers, I can disarm the system twice, stopping the cycle, and immediately ARM the system with no repeated full trigger. Thanks in advance for any help you can provide!