1997 Subaru Legacy Avital 4103 Wont Crank Engine

Home / the12volt's Install Bay / Car Security and Convenience / 1997 Subaru Legacy Avital 4103 Wont Crank Engine

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

boxerlove

Member - Posts: 3

Joined: November 01, 2016

Posted: November 01, 2016 at 12:40 PM / IP Logged

Hello,

Decided to tackle my first remote start install. I am experienced with wiring and reading diagrams but im stumped this time.

Followed my cars wiring diagrams found online and matched up the Acc,Ign,Starter,and 12V Constant wires in the Ignition harness. Properly soldered the connections on. Grounded the Neutral Safety Switch wire, and grounded the main harness ground,Hooked up the Door locks and they work as they should but when i hit the remote start button on the remote the cars dash lights up like i turned the key, Fuel pump primes, and then nothing. The car does not crank. Im a bit confused at what i may have missed? I know its close and has to be something minor. Any and all info is appreciated. Thanks!

Back to Top

boxerlove

Member - Posts: 3

Joined: November 01, 2016

Posted: November 01, 2016 at 12:44 PM / IP Logged

Ive also switched in the Avital menu's to not use the "virtual tach" option . I switched it to Voltage mode thinking that may be it but no luck.

Below i have highlighted the wires i have hooked up to their corresponding wires in the car.

1997 Subaru Legacy Avital 4103 Wont Crank Engine -- posted image.

Back to Top

smokeman1

Platinum - Posts: 1,588

This member has made a donation to the12volt.com. Click here for more info.

This member has been recognized as an authority in Mobile Security and Convenience. Click here for more info.

Joined: September 14, 2009

Location: Wisconsin, United States

Posted: November 01, 2016 at 1:02 PM / IP Logged

You need to connect the other RED H2/6 wire to 12 volts constant

When all else fails, Read the Instructions

Support the12volt.com Make a Donation

Back to Top

boxerlove

Member - Posts: 3

Joined: November 01, 2016

Posted: November 01, 2016 at 1:04 PM / IP Logged

smokeman1 wrote:

You need to connect the other RED H2/6 wire to 12 volts constant

Was just thinking of trying that. Will report back, Hopefully with a starting car ;)! Im going to feel real dumb when it works lol.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.