Avital 5305 L ,dball2 2011 Honda Pilot

Home / the12volt's Install Bay / Car Security and Convenience / Avital 5305 L ,dball2 2011 Honda Pilot

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

rayw

Member - Posts: 1

Joined: December 24, 2016

Location: Pennsylvania, United States

Posted: December 24, 2016 at 6:10 PM / IP Logged

Just put an avital 5305L with dball2 (firmware honda56 program type 1) in a 2011 Honda Pilot.

Alarm functions all work and keyless entry function as well as hatch glass work fine. However when attempting to remote start the unit fails to even initialize. Dball2 doesn't blink, the two way remote shows rx then tx (shows signal sent and signal from module back to remote received. ) but doesn't light up dash or energize any of the primary heavy gauge wires ign, acc,acc2, starter etc. the feed side is hot at all times all fuses are good it is as if the brand new 5305 main module has an internal relay issue. I've gone over all connections and the D2D cable is good and properly connected. All connections are crimped, soldered, and sealed no t tap or shady wiring. Has anyone run into a similar problem ? Kinda ruined a Christmas surprise :(

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.