Here are my suggestions on debugging the install:
1.) You need Avital Black/White: (-) PARKING BRAKE/EMERGENCY BRAKE INPUT connected to Ground. If you installed the toggle switch in series with the black/white wire make sure the switch is in the on position.
2.) Your FLCAN wiring reads:
ORANGE - DATA (J1850) to white/violet on SKIM immobilizer module (cut, car side)
WHITE/BLACK to white/violet on SKIM immobilizer module (cut, plug side)
PINK - IGNITION (+) INPUT and WHITE/RED to pink/white on SKIM immobilizer module
--White/violet Data wire on SKIM immobilizer should NOT be cut. Wire FLCAN Orange to WHITE/VIOLET of SKIM immobilizer module
--SKIM Ignition should be cut, and wired as:
WHITE/BLACK to PINK/WHITE on SKIM immobilizer module (cut, plug side)
Pink Ignition and White/Red to PINK/WHITE on SKIM immobilizer module (cut, car side)
3.) Make sure your fuses are good and pushed fully in on heavy gauge wires. Double check the satellite relay connectors are firmly seated, even the ribbon cable connection from satellite module to main module at both ends.
4.) Unlock car and get into programming menu 3. Change Tach monitor to "OFF" to debug your connections. You can turn this on after you have the Remote start Debugged.
5.) Try the remote start. If it doesn't work, check diagnostics:
Shutdown diagnostics
To perform shutdown diagnostics:
1. With the ignition OFF, press and hold the Valet/Program switch.
2. Turn the ignition ON and then back OFF while holding the Valet/Program
switch.
3. Release the Valet/Program switch.
4. Press and release the Valet/Program switch. The LED flashes on the control
center to report the last shutdown for one minute or until the ignition
is turned on, as shown in the following table:
LED Flashes Shutdown Mode
1 Timed out
2 Over-rev shutdown
3 Low or no RPM
4 Transmitter shutdown (or optional push button)
5 (+) Brake shutdown
6 (-) Shutdown (H3/4 GRAY) or (+) Shutdwon (H3/3
BROWN)
7 (-) Neutral safety shutdown (H3/1 BLACK/WHITE)
8 Wait-to-start timed out
Hope this helps.
Lectric Guy