Vehicle DIY Security

Home / the12volt's Install Bay / Car Security and Convenience / Vehicle DIY Security

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

airschatz

Member - Posts: 1

Joined: January 06, 2020

Location: Texas, United States

Posted: January 06, 2020 at 9:19 AM / IP Logged

I have a Silverado SS and when I bought the truck, there was already a DIY system in place. I am trying to find out how it works and how it is wired. Here is the details that I do know.......

There is a toggle switch under the dashed, 1 side is to ground and the other side is to a set of 3 relays. When switched on, the vehicle will not start (I am assuming it is killing the fuel pump), a flashing LED light started flashing, and when you try to crank the vehicle, the horn blows as you crank and stops when you let off the ignition.

Does anyone have any ideas of how this would be wired, I would like to do this to my other vehicles.

Thanks in advanced.

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.