DEI 535T Troubleshooting on Electric Cutouts

Home / the12volt's Install Bay / Car Security and Convenience / DEI 535T Troubleshooting on Electric Cutouts

Welcome Guest :)

Members

< Prev Topic Next Topic >

sofakingslow

Member - Posts: 15

Joined: December 15, 2005

Posted: May 09, 2020 at 6:23 AM / IP Logged

I installed a 535T as a standalone to make opening and closing my electric cutouts one touch rather than holding the single DPDT switch. Made all my connections according to the instructions for a Type A (dipswitch #3 ON) two window install, because there are two DC motors and no module in the circuit.

When I ground the red/white wire to "learn" the limits of open and close, I get a short movement, then nothing. Holding for 10 seconds or more gets short movement when I press and then nothing.

Troubleshooting Section of documentation covers this issue, but there is no module and "helping the window" open or close does not help. It seems as if the 535T will not enter Learn Mode because I get immediate movement, rather then a delay before cycling open and closed.

Have I missed a connection? Maybe a basic principle? Should I start Learn with the cutouts halfway open?

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.