help 1989 Taurus Dr Locks W/ Key Entry

Hello,

I recently got a clifford Intelliguard IQ800 Car Alarm and i am trying to install it in my 1989 Ford Taurus SHO, it has keyless entry and i know that The "Pnk/Lt. Grn" wire is for unlock, and that the "Pnk/Yel" wire is for lock. But i am confused when i look at my IQ800 wiring diagram it says:

Door Lock Comm, Door Lock NO, Door Lock NC, Door Unlock Comm, Door Unlock NO, Door Unlock NC.

I cant seem to figure out what to do because the ford wiring diagram for my car only shows the unlock, lock and ground wires for the lock switch and the clifford alarm needs 6 wires? I think that i can just connect the unlock and lock wires to the door lock comm and door unlock comm wires on the alarm and leave the other 4 wires disconnected but i want to verify that i am right.

Also, what type of lock is the Type B lock exactly, where does it fall into the wiring diagrams available here on the12volt.com?

I appreciate any help,

Heres a pic of the wiring diagram for the door lock, can someone tell me where all the wires go? are you sure its a negative type?

Thanks,