autostart AS-6000 TW

Home / the12volt's Install Bay / Car Security and Convenience / autostart AS-6000 TW (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

godsegoizhuge

Copper - Posts: 214

Joined: December 12, 2002

Location: United States

Posted: October 06, 2003 at 4:03 PM / IP Logged

I just installed this alarm on a 2004 grand am. Everything works BUT the remote start feature. I think I hooked up the wires to the right ignition wires at the switch, but when i goto remote start it does notta and the parking lights flash 3 times. I took the meter and checked out the wires, everything is working. I even programmed for tach signal like the installation manual states to do, so that works. So now i'm lost on what it could be. Normally i work on DEI alarms, so that's why this one has me cornfused.

Back to Top

HamiltonAudio

Silver - Posts: 278

Joined: October 15, 2003

Posted: October 17, 2003 at 9:38 AM / IP Logged

flashing 3 times is a diagnostic protection....either your pinswitch is open (or screwed), or its in valet mode. is the led on solid? if so, take it out of valet mode (if its a new model, key on/off 5 times). Otherwise, try swapping another unit in....

b

Back to Top

derek123

Copper - Posts: 163

Joined: October 09, 2003

Location: Canada

Posted: October 17, 2003 at 9:59 AM / IP Logged

3 flashes is either:

3 fast flashes: tach watch lock out. - the module has gone through a start cycle and not seen a tach signal, this could be due to a bad tach, or an anti theft problem ( the anti theft is not allowing the starter motor to spin).

1 flash then 2 quick: the voltage to the module is dropping below the threshold of the chip, the module turns off, when the voltage recovers, then module powers back up ( the first flash confirms the start comand, and the 2 flashes are when the module powers back up)

Back to Top

HamiltonAudio

Silver - Posts: 278

Joined: October 15, 2003

Posted: October 19, 2003 at 11:35 AM / IP Logged

have seen the three fast flash thing on a unit where the pin wire was shorted to ground. also on units when you try to start with hood open (again, pin grounded).

too many variations!!!!! I also HATE that "fast" tach programming on the new units....

b

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

autostart AS-6000 TW

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.