Clifford Alarm range

Home / the12volt's Install Bay / Car Security and Convenience / Clifford Alarm range (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

IIrjII

Copper - Posts: 103

Joined: October 12, 2003

Posted: October 12, 2003 at 2:17 AM / IP Logged

Hello all. I am new to the forum and tried to do a search on this particular problem, but got no results. I have installed a Clifford RS2 in my car and the alarm works great. But I noticed that the antenna that came with the alarm was a little bent so i just switched it with another antenna from a friend that workds at a store that carries the RS2. I installed the remote start and keyless entry and also the trunk popper. My problem is that i do not have very good range with the alarm. People are telling me that i am suppose to have pretty good range with it. I can't arm/disarm or remote start my car from more than 20ft away. I should have a longer range than that right? Did switching the antenna cause this problem? Was i suppose to switch more than that or was i suppose to make brain of the alarm learn the new antenna? Or is the antenna i have just a bad one? Thanks for the help in advance.

IIrjII

Copper - Posts: 103

Joined: October 12, 2003

Posted: October 12, 2003 at 9:31 PM / IP Logged

Anybody????

rudbwoy69camaro

Silver - Posts: 350

This member has made a donation to the12volt.com. Click here for more info.

Joined: June 10, 2003

Location: United States

Posted: October 12, 2003 at 10:18 PM / IP Logged

how is the wire from the brain to the antenna? It says to "stretch it all out." Where did you place the antenna?-windshield, rear window?

Search for other posts by rudbwoy69camaro

daniel2002p

Silver - Posts: 524

Joined: October 10, 2003

Location: United States

Posted: October 12, 2003 at 10:24 PM / IP Logged

as stated before stretch all the antenna cable out and do not bundle it up and place it on top of your windshied for best reception. all antannas are same and no programming should be neccesary.

2005 Toyota Corolla S

1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

IIrjII

Copper - Posts: 103

Joined: October 12, 2003

Posted: October 12, 2003 at 11:31 PM / IP Logged

Thanks, i'll try that. Also, is there a way to hook up my trunk popper so i don't have to hold the button down on the remote. I just want to be able to pop my trunk without holding the button down. Thanks

IIrjII

Copper - Posts: 103

Joined: October 12, 2003

Posted: October 12, 2003 at 11:34 PM / IP Logged

Also, the antenna is on the front windshield

sroth140

Silver - Posts: 513

Joined: August 27, 2003

Location: United States

Posted: October 13, 2003 at 12:31 AM / IP Logged

where on the windshield? hopefully in the center.

i had a matrix rs2 that wouldnt get any reception if the car was hot. i swapped brains and remotes and junked out the defective one.

if you can, have your friend swap the brains and remotes. also, channel 2 is setup for a 1.5sec transmission to send and output. if you press it less it will scilence the chirp. if you want to use ch.4 (H2/3 violet/black (-)200 mA programable output), you can do latched, latched/reset with ignition, 30sec timed, and second lock output. if you want to work with it from there Clifford Alarm range -- posted image.

IIrjII

Copper - Posts: 103

Joined: October 12, 2003

Posted: October 14, 2003 at 11:40 PM / IP Logged

The antenna is on the center or the windshield. They don't sell the RS2 anymore, so I'm SOL on that. I'll try the ch.4 and see if I like it. Thanks

IIrjII

Copper - Posts: 103

Joined: October 12, 2003

Posted: October 14, 2003 at 11:43 PM / IP Logged

If I want to upgrade to the matrix RS3.5, will it be hard? Can I just take the brain, antenna, and remote from the RS 3.5 and just swap it with the RS2 and use the existing wires?

sroth140

Silver - Posts: 513

Joined: August 27, 2003

Location: United States

Posted: October 14, 2003 at 11:58 PM / IP Logged

negative. the biggest change for the 3.5 is the relay pack. totally redesigned and its internal. similar to an avital 4000/4200 (its also DEI). youre best bet is to get a matrix rs3 and just order the 3.5 style remote from DEI and program it to your system. the learn routine is in the book.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Clifford Alarm range

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.