viper 791xv trunk release

Home / the12volt's Install Bay / Car Security and Convenience / viper 791xv trunk release (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

Honda99

Member - Posts: 21

Joined: October 25, 2003

Location: Canada

Posted: November 16, 2003 at 9:26 PM / IP Logged

i have a honda 99 ex 4dr, i don't know why when i lock the door and then i open the trunk by remote.All the door and trunk open at a same time. and an alarm trigger. normally with the factory alarm if i lock all the door and then i open the trunk. it open only the trunk. please help

mazdatruckin

Copper - Posts: 69

Joined: September 10, 2003

Posted: November 17, 2003 at 1:29 PM / IP Logged

Hold on a sec.. Is it a 99 CIVIC? ACCORD? etc.??? Did you add a trunk release? Or is it factory? So when you open just the trunk, everything opens? Sometimes you have to program the alarm to disarm when using the trunk pop. Let me know what alarm, what car. It would really help. What you say is quite vague.

Honda99

Member - Posts: 21

Joined: October 25, 2003

Location: Canada

Posted: November 18, 2003 at 12:10 AM / IP Logged

oh sorry........it's 99 Accord EX. i have a viper 791xv. The car itself have a trunk pop up. but i want to use one remove instead of 2 remote(Viper & Honda remote). so i run a relay for a trunk from a viper. but do'nt know why when lock the door and then open the trunk all the door lock/trunk open at a same time and the dome light on. alarm start to trigger.

mazdatruckin

Copper - Posts: 69

Joined: September 10, 2003

Posted: November 18, 2003 at 8:09 AM / IP Logged

hmm is the factory alarm going off? Or is it the Viper?Make sure you're getting the WHITE/ red wire for your trunk pop. Are you using the RED / white wire from the viper to activate the relay?

Did you hook up the factory disarm wire? because this car disarms when unlocked. so it might be that its sensing channel 2 and disarming the car, but then the alarm going off doesnt make any sense. hmm lemme know which alarm is going off. also you are using the viper remote yes? Also check your grounds everywhere and let me know how u have the relay setup.

mazdatruckin

Copper - Posts: 69

Joined: September 10, 2003

Posted: November 18, 2003 at 8:14 AM / IP Logged

there is a seperate disarm wire for the accord tho, try this... first disarm the car with the factory remote, then use the trunk pop. Does it work? IF so, then the problems is somewhere between the factory alarm and yours.

Honda99

Member - Posts: 21

Joined: October 25, 2003

Location: Canada

Posted: November 21, 2003 at 1:19 AM / IP Logged

yes, i did hook up the factory disarm H2/1 (GREEN/ black) wire to the factory disarm output power door unlock(orange from the passengers fuse box). it work well when i start the car. i use H1/12 (RED / white)wire grom the viper to the relay and connected to(WHITE/ red)wire for trunk popup. i use the viper remote to open the trunk. if unlock the door and then open the trunk everything work fine. if lock the door and then open the trunk. alarm going off.

mazdatruckin

Copper - Posts: 69

Joined: September 10, 2003

Posted: November 21, 2003 at 12:26 PM / IP Logged

ok did you have the factory disarm wire programmed to actiave when you do channel 2? It #9 in the 2nd programming options. That will disable the factory alarm.... but ulocks the doors... Is your new alarms siren going off??? Do you have a trunk pin connected on the blue wire? It may be sensing the trunk open while armed and is triggering the system. Let me know WHICH alarm is going off, factory or new Viper.

let me know which alarm (factory or viper), and then we can solve the problem.

mazdatruckin

Copper - Posts: 69

Joined: September 10, 2003

Posted: November 21, 2003 at 12:29 PM / IP Logged

ok here's something that might help a little if its the factory alarm going off... The Viper should allow you time to open the trunk and shut it, as long as you have zone bypass set. in the options.. if the factory alarm is going off you can disarm using the GREEN/ black and split it off to a blue wire in the driver's door located at the power window switch. That will give you a disarm with no unlock. Like i said, lemme know which alarm is sounding off.

Honda99

Member - Posts: 21

Joined: October 25, 2003

Location: Canada

Posted: November 21, 2003 at 4:12 PM / IP Logged

ok...to reply a question you're asked which alarm going off it's the viper alarm goes off.i did programming again menu #2-9 features. if Set in OFF the factory alarm goes off but the door still lock.Set ON the viper alarm goes off and the door unlock...so right now i set it ON position.The trunk pin H1/6 BLUE connected to ORANGE(drives kick panel).i did different from the factory alarm disarm wire is intead connect the H2/1 GREEN/ Black to Blue wire(drivers power window switch). i connected to Orange(unlock from the passengers fuse box). because i think it is a same door unlock and it work fine when i start a car.

profuse007

Gold - Posts: 2,015

Joined: October 20, 2002

Location: Texas, United States

Posted: November 21, 2003 at 4:54 PM / IP Logged

-dont use the orange wire for disarm.

-what youre doin is not disarming, but you r unlock your car while the viper is still arm.

-the disarm wire h2/1 GREEN/ black is to disarm factory alarm, hence the blue wire at the door like you mentioned

-ithink the reason why it works when you remote start cause the viper disarm itself.

BTW the trunk pin is crap, it doesnt show up on the lcd when you open the trunk. it only show up when that alarm zone set off.

Houston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.