2000 bmw 328ci remote start

I am looking to install a remote starter. Looking for vehicle wiring diagrams and any info if bypass parts are needed.

good luck

 ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

12V|RED / grn & RED / blu   |+  |ignition harness            |STARTER|BLACK/ blue          |+  |ignition harness            |IGNITION|green               |+  |ignition harness            |SECOND IGNITION|purple              |+  |ignition harness            |POWER LOCK|blue/red            |-  |54 pin plug, pin #22 @ *1   |POWER UNLOCK|WHITE/ black *3      |-  |54 pin plug, pin #20 @ *1   |LOCK MOTOR|white (any one of 5)|   |54 pin plug @ *1            |UNLOCK MOTOR|blue                |   |54 pin plug, pin #35 @ *1   |DISARM DEFEAT|(chassis ground)    |   |                            |PARKING LIGHTS +|*4                  |   |                            |HEADLIGHTS|                    |   |                            |DOOR TRIGGER|RED / blue            |+  |54 pin plug, pin #18 @ *1   |DOME SUPERVISION|comes on with unlock|   |                            |TRUNK/HATCH PIN|WHITE/ brown         |-  |drivers kick panel          | HOOD PIN|PURPLE / green        |-  |26 pin plug, pin #7 @ *1    |TRNK/HTCH RELEASE|gray/green          |+  |54 pin plug, pin #17 @ *1   |FCTRY ALARM ARM|arms with lock      |   |                            |FCTRY ALRM DISARM|disarms with unlock |   |                            |TACHOMETER|black               |   |diagnostic plug *2          |SPEED SENSE|BLACK/ white         |   |radio, pin #10              |BRAKE WIRE|BROWN / white         |+  |brake pedal switch          ||     HORN TRIGGER|PURPLE / blue         |+  |horn relay *5               ||Notes:NOTE: This vehicle is equiped with the EWS II immobilizer system that need to be bypassed when adding a remote start. Use DEI module 555B and refer to directfax document #1056 for additional wiring information.  *1 The general module is a white box located behind the glove box. The 54 pin plug is the center plug, and the 26 pin plug is the one on the left.  *2 The diagnostic plug is on the passengers side of the engine compartment.  *3 On some models, unlock may require a double pulse.  *4 Need to remove the light switch module from the dash and pop off the front cover. A ribbon cable which connects the switch to the module will be exposed. With the switch facing towards you, you need to interrupt the fourth wire from the left with a relay. When interrupted the parking lights will come on. See directfax document # 1055 for wiring information.  *5 The horn relay is above the general module. It is the green relay to the right of an orange relay.  *6 Extended triggers on the door lock wires will roll the windows up/down and open/close the sunroof. Use validity channels to control.

Luis

Sound Waves

Is up to the installer to test all wires with a DMM whenever possible.