2002 ram 1500 remote start

Remote Starter Wiring Colors and Notes

Function

Start:

Ignition #1:

Ignition #2:

Ignition #3:

Accessory:

Brake Light:

Tach Signal:

Parking Lights:

Headlights:

Diesel Glow Plug:

Clutch Bypass Wire:

NOTES: * This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 1.4 K-Ohm Resistor. Headlights Need To See A Ground (-) Through A 1.8 K-Ohm Resistor. ** Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. *** Tach can also be located at pin 74 behind instrument cluster.

Alarm and Keyless Entry Wiring Colors

Function

Constant +12 Volts:

PINK/BLACK

IGNITION SWITCH HARNESS

OEM Alarm Disarm:

LT. GREEN/ ORANGE *****

HARNESS COMING IN FROM DRIVER'S DOOR

Dome Lights/Superv:

SEE NOTE ***

OEM Horn:

BLACK/ RED (-)

STEERING COLUMN HARNESS

Power Lock:

WHITE/ GREEN

DRIVER'S KICK PANEL ****

Power Unlock:

WHITE/ GREEN

DRIVER'S KICK PANEL ****

Trunk Release:

N/A

Alarm Input Wire:

SEE NOTE ***

NOTES: *** Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. **** Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. ***** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor.