Need Wiring Info - 2002 Mercury Cougar

Looking for wiring info from deitechs for 2002 Mercury Cougar.

Any and all information you can give on this car.

First time install of 791xv.

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

|              12V|red                 |+  |ignition harness            ||          STARTER|gray/white          |+  |ignition harness            ||         IGNITION|green               |+  |ignition harness            ||        ACCESSORY|yellow              |+  |ignition harness            ||       POWER LOCK|YELLOW /GREEN        |-  |drivers kick panel          ||     POWER UNLOCK|WHITE/ green         |-  |drivers kick panel          ||       LOCK MOTOR|yellow/black        |   |drivers door harness        ||     UNLOCK MOTOR|WHITE/ black         |   |drivers door harness        ||    DISARM DEFEAT|WHITE/ green         |   |passenger door harness      || PARKING LIGHTS +|RED / blu & RED / yel *5|   |headlight switch            || PARKING LIGHTS -|BLACK / YELLOW        |   |keyless module *1           ||     DOOR TRIGGER|blk/red & blk/grn *2|-  |top of the fuse box         || DOME SUPERVISION|BLACK/ blue          |-  |drivers 'A' pillar          ||  TRUNK/HATCH PIN|BLACK/ orange        |-  |drivers running board *3    ||TRNK/HTCH RELEASE|BLACK / YELLOW        |-  |at switch or drivers kick   ||FCTRY ALRM DISARM|BLACK/ white         |-  |drivers kick panel          ||       TACHOMETER|BROWN / green         |   |ignition coil pack          ||      SPEED SENSE|WHITE/ blue          |   |*4                          ||       BRAKE WIRE|ORANGE / blue         |+  |brake switch                ||     HORN TRIGGER|BLACK/ blue          |-  |ignition harness            ||  LF WINDOW UP/DN|wht/pur - yel/pur   |A  |drivers door switch         ||  RF WINDOW UP/DN|white - yel/grn     |A  |drivers door switch         |

Notes:

NOTE:  This vehicle is equipped with PATS (Passive Anti Theft System).  Use DEI module 555F to over-ride during remote start.  *1 The keyless module is located behind the glove box. This wire flashes the hazard lights.  *2 Use BLACK/ red for the drivers door and BLACK/ green for the passengers door.  Diode isolate each wire together to the alarm. To access these wires, pull fuse panel down and remove cover.   *3  Towards the rear of the running board.  *4 Located between the firewall and the strut tower on the drivers side of the motor in a 10 pin connector.  *5 These wires must be relay isolated from the headlight switch to keep the headlights from flashing with the parking lights.

Jeff

Velocity Custom Home Theater

Mobile Audio/Video Specialist

Morden, Manitoba CANADA