Audi 90 Keyless entry installation

I'm looking to install a keyless entry system on a 1993 Audi 90 with an existing keyless entry system that isn't working. I assume all of the stock hardware, i.e., door lock actuators, etc, will be sufficient. Does anyone know where I could find the factory wiring diagrams for this installation or have any ideas as to the best way to go about this? Thanks.

Make:   Audi Model: 90 Year:    1993-94 This Database Was Last Updated On:    4/7/2004 Index #: 2217 Alarm Constant 12 volts RED AND RED IGNITION SWITCH HARNESS Ignition 12 volts BLACK IGNITION SWITCH HARNESS Starter RED / BLACK IGNITION SWITCH HARNESS Dome Light BROWN / BLUE (-) AT ANY PIN SWITCH Trunk Pin Switch BROWN / BLUE (-) TRUNK PIN SWITCH OR BROWN / WHITE AT LIGHT Parking Lamp DRIVER - GREEN/ BLACK PASS. - GREEN/ RED (+) HEADLIGHT SW. Power Lock BROWN / WHITE CENTRAL LOCKING/ALARM UNIT BELOW #204 Power Unlock BROWN / GREEN PASSENGER REAR SEAT * #201 * GREEN/ BLUE Single Wire Dual Polarity At Door Lock Switch. BROWN / GRAY And BROWN / GREEN From Trunk Switch (WHITE/ YELLOW & WHITE/ BLACK At Switch), Pulse Time Not Known. Alternate Method Is To Add Actuator To Driver Door. #201- See Negative Pulse Door Lock Diagram. #204- See Adding Actuator Door Lock Diagram. Good Luck

David

Ace Security

813-376-9778

Tampa

Donate to the 12volt

Thanks for the info, hopefully everything will go smoothly!