viper 550 esp install question

Home / the12volt's Install Bay / Car Security and Convenience / viper 550 esp install question (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

Patrick27

Member - Posts: 1

Joined: July 05, 2004

Location: United States

Posted: July 05, 2004 at 12:50 PM / IP Logged

I had a viper 550 esp remote starter alarm intalled "profesionally" now I am having problims with it the car wont start normally it acts like the battery is dead just clicks if I cycle the ignition a few times eventully it will start. but when it dont start I pull the key out of the ignition the car will try to start itself just has a loud clicking untill I press the brake that is the only way to stop it. the strange thing to me is that after I get the car started it works fine if I restart it right away if it sits a few hours I have the same problims I already put a new battery in it. I looked at the splices cheap crimp and t-taps I know that I could have a Number of problims so if no one has a answer can some one get me the wiring digaram for the alarm system I will uninstall the whole thing and re install it or just leave it out the car is a 2001 pont grand prix

Thank you if any one can help

Back to Top

swamprat323

Gold - Posts: 1,335

Joined: September 22, 2002

Location: Florida, United States

Posted: July 05, 2004 at 5:15 PM / IP Logged

| 12V|red & RED / white |+ |ignition harness |

| DOOR TRIGGER|tan and dark blue |- |*1 |

| SPEED SENSE|dk.green |4 |*2 |

Notes:

NOTE: This vehicle is equipped with the pass-key III immobilizer. Use DEI part number 555G or 555U to bypass during remote start mode. *1 The tan is located in the drivers kick and catches only the drivers door. The dark/blue is located in the passenger kick panel and catches all other doors, must diode isolate these wires. *2 Located at a 10 pin plug on the front of the drivers strut tower. There are two dk.green wires there, use the one in the corner of the plug. *3 The PCM (Powertrain Control Module) is in the air cleaner assembly.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

viper 550 esp install question

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.