codealarm csi-100 in 99 chevy blazer?

Greetings,

I plan on installing a codealarm csi-100 keyless entry in my 99 chevy blazer this weekend. according the the manual I need a spdt relay for the starter kill I think I understand that part but One thing I'm not too clear about is the door locking system. I read the instructions on how to find out the type, Can someone save me some grief and tell me the type?

Anything else I should know?Any tips?I already printed the vehicle wiring info from this site.

Thanks

- Jose

    Chevrolet Blazer 1999      Remote start / Security / GPS Wire/Function Colour Location/Description Polarity PASSIVE ANTI-THEFT YES PASSLOCK 2 SEE NOTES 12 VOLTS Red Ignition harness + IGNITION Pink Ignition harness + IGNITION 2 White Ignition harness + ACCESSORY Orange Ignition harness + STARTER Yellow Ignition harness + TACH White At coil on motor AC LOCK Lt.blue At module above driver's kickpanel + UNLOCK White At module above driver's kickpanel + DRIVER LOCK MOTOR Gray At relay block under driver's dash + DRIVER UNLOCK MOTOR Tan At relay block under driver's dash** + DOORPIN White* At courtesy light under dash* - TRUNK PIN Common with doors    TRUNK RELEASE Black At release switch in dash - FACTORY DISARM Lt.green In harness from driver's door - BRAKESWITCH White At switch above brake pedal + PARKLIGHTS Lt.blue At light switch harness + HORN Black At steering column harness - CLUTCH SWITCH PURPLE / white At switch on top of clutch pedal TYPE 1 DRIVER WINDOW UP Dk.blue At switch in driver's door REV POL DRIVER WINDOW DOWN Brown At switch in driver's door REV POL PASSENGER WINDOW UP Blue or Blue/white At switch in driver's door REV POL PASSENGER WINDOW DOWN Tan At switch in driver's door REV POL HEADLIGHTS White At light switch harness + REVERSE LIGHTS Lt.green At steering column harness + DIMMER Dk.green or Gray At dimmer switch harness VSS WIRE Dk.GREEN / WHITE*** VCM in right front engine compartment 4000ppm KEY SENSE Lt.green Ignition harness - DATABUS INTERFACE Pin-2(top row from left) Diagnostic plug below dash DATA Vehicle notes PLEASE NOTE: This vehicle is equipped with GM's new PASSLOCK II system, a fuel cutoff system that you must bypass for remote start. See alarm diagram. The truck's 2nd ignition wire must be connected, or the check engine light will come on and serious transmission damage may result. * There is an domelight override on the light switch. When this switch is turned on, the courtesy light do not come on either. To insure proper protection of the doors, you will need to go directly to the Body Control Module located behind the dash in front of the center console. There you can find a TAN(driver's door), ORANGE(passenger door), BLUE/WHITE(rear doors & hatch). These wires are not affected by the override switch. ** There is more than one wire of this color, please test carefully. *** Pin-3 of the 24-pin BLACK connector. Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in any other way. The information supplied is a guide only. -------------------------------------------------------------------------------- ©2002 Autoland All rights reserved        Printed at: 10/5/2004 7:03:59 PM

DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / BLAZER / 1999 / Remote Start

12volts red   +   ignition harness

Starter yellow   +   ignition harness

Second Starter N/A       

Ignition pink   +   ignition harness

Second Ignition white   +   ignition harness

Third Ignition N/A       

Accessory orange   +   ignition harness

Second Accessory          

Keysense          

Power Lock lt. blue   +   brown plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Power Unlock white   +   brown plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Lock Motor gray   5wi driver kick panel

Unlock Motor tan   5wi driver kick panel

Parking Lights+ brown   +   lt. blue plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Parking Lights- white   -   lt. blue plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

This wire will not test when using the headlight switch. This wire is triggered by the DRL system. To meter the wire, start the car with the parking brake set, when the brake is released this wire will go to ground.

Hazards          

Turn Signal(L)          

Turn Signal(R)          

Reverse Light          

Door Trigger     -   BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Use tan for the drivers door located in pin B4 of the purple plug, orange for the passenger door located in pin B2 of the purple plug, and dk. blue/white for the rear doors and rear hatch located in pin B11 of the lt. blue plug, must diode isolate these wires.

Dome Supervision use door trigger       

Trunk/Hatch Pin pink/black   -   lt. blue plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Hood Pin          

Trunk/Hatch Release black   -   purple plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Power Sliding Door N/A       

Factory Alarm Arm          

Factory Alarm Disarm lt.green   -   purple plug at BCM

Notes: The BCM is located to the right of the accelerator pedal below the radio. The plugs on the BCM face towards the drivers side.

Disarm No Unlock see factory alarm disarm       

Tachometer white   ac   PCM

Notes: The PCM is located on the passenger fender. On the 2.2L the wire is in a black 80 pin plug pin 10, and on the 4.3L the wire is in a red 32 pin plug pin 20.

Wait to start N/A       

Brake Wire white   +   steering column

Parking Brake          

Horn Trigger black   -   steering column

Notes: Also found in the brown plug at the BCM on vehicles with a factory alarm.

Memory Seat 1          

Memory Seat 2          

Memory Seat 3          

Immobilizer Bypass Module: Required: Yes Type: Passlock 2 Part #: 555L or 555T

Notes: N/A