Toyota Tundra Keyless Entry Help

I installed the Crimestopper 2016fm in my 2000 Toyota Tundra. I could not get the door lock or unlock to work. I have the power lock as being WHITE/ green in the Driver Door Harness.The unlock is RED / yellow and it is isolated with a diode with the child safety wire blue/black. Where exactly is the driver door harness? Do i have to take off the cover? I tapped into the wires out of the door and in the front kick panel. This did not work. I ckecked the voltage at the switch and it did get a negative pulse from the alarm but the motors did not activate.Where is the relay located? I am not sure if this car had keyless entry from the factory, but should it matter?

When you diode isolated the unlock wires, you isolated both unlock, and the child safety wire with individual diodes right? And both diodes are tied together leading to the alarms unlock wire. The lock wire does not need to be isolated with a diode, just tap into it with the alarms lock wire. Regards EVIL Teken . . .

Dont know why I got booted off, but here is the rest. Lock wire is WHTITE / GREEN. Unlock wire is RED / BLUE & BLUE / BLACK both of these wires must be diode isolated and wired together for them to unlock properly. Regards EVIL Teken . . .

Yes, I diode isolated both of them and the wire colors you provided match the ones I used. It still doesn't work. Maybe it's where im tapping into. The diagram i have says the driver door harness(where is this located?). I tapped into the wires that come out of the door through the rubber sleeve.

srusin1 wrote: The unlock is RED / yellow and it is isolated with a diode with the child safety wire blue/black.

The wire is not RED / YELLOW . . . Please check and verify the proper wire is connected to. Regards EVIL Teken . . .

HHMMMMMM.......

2000 Toyota Tundra

Power Unlock

RED / YELLOW

DRIVER KICK PANEL *

* Child Safety Lock - RED / BLUE (-) In Same Connector As Door Locks. Child Safety locks

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

LOL, Directech says the same thing. Wire Magic is what I am referencing too. Let me look up two more data bases. Regards EVIL Teken . . .

Silly question, which direction are the diodes facing? The cathode or band side should be facing the alarm module. Regards EVIL Teken . . .

Yes the cathodes are facing the alarm module to allow negative flow to the lock/unlock wires. I test the wires that i connected to and they do get a negative pulse from the alarm module(same as the pulse from the driver switch). Any word on the wire colors? Also are the relays in the kick panel or under the hood? Thanks for the help Where is this info from: RKE Module     NO OEM KEYLESS PRESENT IN SCHEMATICS           Motor Lock     BLUE/WHITE *     AT RELAYS      Motor Unlock     BLACK / YELLOW *     AT RELAYS      Drv Door Unlock     BLACK / YELLOW *     12 PIN CONNECTOR DRIVERS KICK      OEM Relays     BUILT INTO INTERGRATION RELAY @ DRIVER JUNCTION BLOCK