97 cavalier remote start

Get three relays, wire as follows:

85 on all three relays:  Ground

86 on all three relays:  to the Ignition output of your remote start.

Relays #1 and #2:  30 to constant positive.

Relay #3:  30 to ground.

Terminal 87 on relays #1 and #2 will now be  your two ignition outputs--- one of these goes to the car's pink ignition wire, and the other goes to the white second ignition wire.

Terminal 87 on relay #3 will put out a ground to activate your Passlock bypass module.

Of course, the constant-power inputs going into relays 1 and 2 should be fused....I'd just splice into the fuse(s) that already come with the remote starter.

-------------------------------------------------------------------------------------

|       ITEM      |     WIRE COLOR     |POL|       WIRE LOCATION        |

|              12V|red                 |+  |ignition harness            ||          STARTER|yellow              |+  |ignition harness            ||         IGNITION|pink                |+  |ignition harness            ||  SECOND IGNITION|white               |+  |ignition harness            ||        ACCESSORY|orange              |+  |ignition harness            ||       POWER LOCK|lt. blue            |*2 |either kick panel           ||     POWER UNLOCK|white               |*2 |either kick panel           ||       LOCK MOTOR|gray                |   |drivers kick panel          ||     UNLOCK MOTOR|tan                 |   |drivers kick panel          ||    DISARM DEFEAT|tan                 |   |passengers kick panel       || PARKING LIGHTS +|brown               |   |harness to rear, dkp        ||       HEADLIGHTS|dk. blue            |-  |headlight switch            ||     DOOR TRIGGER|grn/blk & lt. blue  |-  |*3                          ||  TRUNK/HATCH PIN|black               |-  |trunk light                 ||TRNK/HTCH RELEASE|BLACK/ white         |+  |keyless module *4           ||       TACHOMETER|PURPLE / white        |   |engine harness *1           ||       BRAKE WIRE|white               |+  |stop light switch           ||     HORN TRIGGER|black               |-  |steering column             ||           WIPERS|                    |   |                            ||  LF WINDOW UP/DN|dk. blue - brown    |A  |LF window motor in door     ||  RF WINDOW UP/DN|lt. blue - tan      |A  |drivers kick panel          ||  LR WINDOW UP/DN|dk. green - purple  |A  |drivers kick panel          ||  RR WINDOW UP/DN|lt. green - purple  |A  |drivers kick panel          |

Notes:

This vehicle has a the PASSLOCK I key based engine disabling system.  Use DEI part number 555t or 555L to bypass during remote start.  *1 The engine harness is found next to the battery, below the radiator hose, just above the transaxle.   *2 Non keyless cars, locks are 5wi (type C) and they are mastered from the passenger side switch. Keyless cars, locks are positive trigger (type A).  *3 The GREEN/ black is located in the lower drivers kick panel.  It catches the drivers door only.  The light blue is located in the lower passenger kick panel, and catches the passenger door(s).  Tap both wires and diode isolate each.  *4 The keyless module is located in the left side of the trunk behind the rear seat.