DB-PLDATA Question

Home / the12volt's Install Bay / Car Security and Convenience / DB-PLDATA Question (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

wvromania

Member - Posts: 10

Joined: January 17, 2005

Location: United States

Posted: January 17, 2005 at 4:23 PM / IP Logged

I just started reinstalling remote starters after a long layoff due to health reasons....

I have never used a PLDATA before, I have everything figured out except the Brown wire on unit. It states that it should go to "(-) negative ground output when running."

Do i have to run a relay off Ign.(+) to to get the negative. I'm using a Omega as the base unit., it has a satiellite reply port. If i use that do i have to run a relay? or plug stright into the blue (-) there? Sorry for newbie question.

russ lund

Copper - Posts: 188

Joined: April 07, 2004

Location: United States

Posted: January 17, 2005 at 5:10 PM / IP Logged

The remote starter should have a( -) out when running wire.If it does not your idea would work.

BigDog

mobileworks

Copper - Posts: 136

Joined: December 16, 2004

Location: United States

Posted: January 17, 2005 at 9:21 PM / IP Logged

note though that you may run into problems when doing this because the pldata runs on the data bus. So by the time that it takes for the unit to turn on and communicate with the vehicle via the data bus the ignition system has been on the whole time....and that might confuse the vehicles computer and not diable the passlock system....

The data interfaces usually need 2-4milliseconds before the ignition system powers up....Although this is not a problem on most vehicle this problem does happen and something you should be prepared for.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

DB-PLDATA Question

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.