CrimeStopper cs-2011RS3

I installed the CrimeStopper cs-2011RS3 Remote Start Alarm in a 199 HONDA Accord LX, using the PKH2 Bypass Module.I have 2 issues:

1. When attempting to remote start the car via remote, I get parking light flashing, but NO crank. Another attempt with the key in place was unsuccessful.

2 Door Lock feature only works with Driver Side Front & Rear. Connected Door Lock & Unlock of alarm to the BLACK/ White & GREEN/ red located on the 2 pin connector by the driver side fusebox.

3.Recieved Check Engine Light after attempt.

4.Battery Died

I guess I will close this thread because all the issues have been resolved.  To anyone who is wondering, the solution to the above points are :

1. A Starter Disable was also installed, so the starter was cut and a relay was placed. The Ignition from the alarm must be connected to the starter side (instaed of the key side).

2. The BLACK/ White and GREEN/ Red is the correct wire for Lock and Unlock, respectively. However, in my case the actuator on the passenger (front & rear) have failed. They need replacement...

3 CEL was due to a defective battery. Once replace with a new one, Check Engine Light gone!!

4. Battery was 6 years old. Average lifesapn of a battery is 5...

End of Story!!!