adding 508D to Viper791xv

Home / the12volt's Install Bay / Car Security and Convenience / adding 508D to Viper791xv (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

rsmi500

Member - Posts: 3

Joined: April 23, 2005

Location: United States

Posted: May 01, 2005 at 4:23 PM / IP Logged

I already have Zone 2 being used by my audio sensor in tandem w/the shock sensor....from the 508D, I connected both the blue and green to the Blue (Zone4) on the H1 harness. But now the sensor doesn't have the "dual zone" effect. Anytime I violate the first field it goes to full alarm...Is it because I have the blue/green wires connect to the same input? Is there a better place to connect the blue/green wires from the sensor?

gcorrea

Silver - Posts: 436

Joined: May 22, 2004

Location: United States

Posted: May 02, 2005 at 10:42 PM / IP Logged

any time you wire multiple sensors into the same input you should diode isolate. try it if you didnt, post your results.

gcorrea

rsmi500

Member - Posts: 3

Joined: April 23, 2005

Location: United States

Posted: May 09, 2005 at 9:11 PM / IP Logged

Oh yeah I forgot about that...But I just realized that the factory harness for the shock sensor has a loose green that instructs you to connect both a green and blue output to this w/o diodes as it's designed for this. So I connected the proximity sensor to the shock sensor and plug the shock sensor into the main unit. Then, I cut the harnes wires to the glass-break sensor and hard wire the ground and power to proper points...A since there in only one trigger for this sensor, I connected to the Zone 4 wire (blue) on the main unit..Works perfect now!! Thanks for your response Gcorrea...

rsmi500

Member - Posts: 3

Joined: April 23, 2005

Location: United States

Posted: May 09, 2005 at 9:22 PM / IP Logged

-Also, now I have this problem w/the motion sensor when it rains...the rain drops rolling along the window trigger the warning chirp. I tried adjusting the setting a little lower, but now it doens't trigger when someone comes up to the window.....any ideas?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

adding 508D to Viper791xv

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.