keypad type ignition cutoff

Home / the12volt's Install Bay / Car Security and Convenience / keypad type ignition cutoff (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

peter

Member - Posts: 1

Joined: April 18, 2002

Location: United States

Posted: April 30, 2002 at 4:27 PM / IP Logged

Please help with putting the keypad into valet mode. Note: I have a green light where the pound button would normally be found.

Thinkster

Copper - Posts: 94

Joined: March 27, 2002

Location: United States

Posted: May 01, 2002 at 12:41 PM / IP Logged

Are you saying there is no # button or just that it has broken off? Haven't used these in a long time, but I think Valet mode was a combination of # and * or 1 and #. Assuming the # key has brocken off, most of the rubber type keys have a conductive coating that touches a grid/finger type pattern of the circuit board for that paticular key. If you can see this, you can try sticking something conductive like a small flat screwdriver or a shaped piece of aluminum foil to touch the area where the keypad would have on the circuit board. This is no permanent solution, just a temp to "press" that key.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

keypad type ignition cutoff

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.