DIRECTWIRE™ WIRING INFORMATION - PLYMOUTH / VOYAGER / 1996 / Remote Start
12volts red + ignition harness
Starter yellow + ignition harness
Second Starter
Ignition blue + ignition harness
Second Ignition BLACK/ orange + ignition harness
Third Ignition
Accessory BLACK/ white + ignition harness
Notes: Not required for remote start.
Second Accessory
Keysense
Power Lock WHITE/ green left plug at bottom of fuse
Notes: Use relays and set up for negative trigger. Place a 4020 ohm resistor inline on the lock output, and a 665 ohm resistor inline on the unlock output. If you do not have a factory security system use a 1500 ohm for lock and a 250 ohm for unlock.
Power Unlock same wire box under cover (1 of 3)
Lock Motor BROWN / white
Notes: The door lock motor wires are located in the top left plug at the relay/fuse box under the drivers side of the dash.
Unlock Motor BLACK/ pink
Notes: The door lock motor wires are located in the top left plug at the relay/fuse box under the drivers side of the dash.
Parking Lights+ do NOT use
Parking Lights- grn/wht or grn/red at light switch
Notes: If the van has *auto lamps*, see direct fax document # 1080
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger BROWN / lt. green - dome light on/off switch
Dome Supervision BROWN / white - dome light on/off switch
Trunk/Hatch Pin tied in with doors
Hood Pin do not use
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm arms with lock
Factory Alarm Disarm disarms with unlock
Disarm No Unlock see directfax #1081
Tachometer gray or gray/red AC ignition coil
Wait to start
Brake Wire WHITE/ tan + brake switch
Parking Brake
Horn Trigger BLACK/ red - steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3
Interface Module: Category:
Immobilizer Bypass Required:
No Type:
N/A
Part #: N/A
Notes:
Interface Module: Category:
Door Lock Interface Required:
Yes Type:
Multiplex
Part #: 456LW
Notes:
This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.
Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information.
Be careful whose advice you buy, but be patient with those who supply it.