Can’t find valet switch

Home / the12volt's Install Bay / Car Security and Convenience / Can’t find valet switch (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

gmpm5754

Member - Posts: 2

Joined: August 06, 2005

Location: United States

Posted: August 06, 2005 at 8:13 AM / IP Logged

I just purchased a 95 Chevy Blazer that has an Autopage RF-305 alarm system. I purchased a second remote for my wife and went to Autopageusa site for instructions. The instructions said to press a valet switch 3 times but I haved looked all over for this switch and can't find it. Does it have to have one? Could someone of put it in without it? Does anyone have a wiring diagram for this unit so I could find which wire it would be? Sorry about all the questions. I'm just lost.

Thanks,

gmpm5754

Back to Top

azdoi

Member - Posts: 17

Joined: August 05, 2005

Location: United States

Posted: August 06, 2005 at 12:16 PM / IP Logged

Does the alarm have an LED that flashes when it's armed?? If so try to follow the wire from it back to the alarm brain, then from there you can chase wires running out from there. I'm no 100% sure about Autopage, but most alarms use a small 2 pin plug into the alarm brain and the other end will be a small black button. Try that method but depending on the alarm installer, he could have gotten very "creative" with the mounting location. Most common locations are drivers kick panel area or under the dash on the drivers side

Back to Top

swamprat323

Gold - Posts: 1,335

Joined: September 22, 2002

Location: Florida, United States

Posted: August 06, 2005 at 7:37 PM / IP Logged

can yuo find the alarm, if so the plug END is blue and trace it form there.

Back to Top

gmpm5754

Member - Posts: 2

Joined: August 06, 2005

Location: United States

Posted: August 07, 2005 at 9:56 AM / IP Logged

Yes it does have a led that flashes. I followed it back and by pulling the dash bezel off I fould the actual brain box. On it it says Autopage RF-305. I did see a blue connector with 2 wires coming out of it. I'll trace that and see where it goes. Thanks for the repies,

gmpm5754

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Can’t find valet switch

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.