Wiring Diagram for 98 dodge ram 1500

Home / the12volt's Install Bay / Car Security and Convenience / Wiring Diagram for 98 dodge ram 1500 (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

jimmy02

Member - Posts: 4

Joined: December 03, 2002

Location: United States

Posted: December 03, 2002 at 8:02 PM / IP Logged

I found wiring diagram for the 99' dodge ram I'm curious and hopeful that the wiring for the 98' ram was the same. Does anyone know for sure ? I'm installing a Valet 552T remote starter.

diabloed

Copper - Posts: 133

Joined: August 25, 2002

Location: United States

Posted: December 03, 2002 at 10:31 PM / IP Logged

<>12volts	red and pink/black	+	ignition harness
<>Starter	yellow	+	ignition harness
<>Second Starter	none
<>Ignition	dk. blue	+	ignition harness
<>Second Ignition	BLACK/ orange	+	ignition harness
<>Third Ignition	none
<>Accessory	BLACK/ white	+	ignition harness
<>Second Accessory	none
Keysense
<>Power Lock	ORANGE / purple	5wi	driver door harness
Notes: Keyless models use positive trigger for lock, and 5-wire for unlock. Can also find wires at the central timer module to the right side of the steering column, lock is ORANGE / green, unlock is pink/green.
<>Power Unlock	pink/purple	5wi	driver door harness
Notes: Keyless models use positive trigger for lock, and 5-wire for unlock. Can also find wires at the central timer module to the right side of the steering column, lock is ORANGE / green, unlock is pink/green.
<>Lock Motor	none	non	none
<>Unlock Motor	none	non	none
<>Parking Lights+	BLACK / YELLOW		drivers kick panel
<>Parking Lights-	none
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
<>Door Trigger	yellow	-	drivers kick panel
Notes: To avoid dome delay, use tan for the drivers door and BLACK/ lt. blue for the passenger door. Both wires are located at the central timer module to the right side of the steering column. Use both wires and diode isolate each.
<>Dome Supervision	none	non	none
<>Trunk/Hatch Pin	none
<>Hood Pin	none
<>Trunk/Hatch Release	none
Power Sliding Door
<>Factory Alarm Arm	arms with lock
Notes: Must see a ground on the tan drivers door trigger wire while locking to arm the factory alarm. This only works if the vehicle does not have delayed domelight.
<>Factory Alarm Disarm	lt. GREEN/ orange	-	harness from door
<>Disarm No Unlock	none	non	none
<>Tachometer	BLACK/ gray	AC	ignition coil
Notes: Diesel tach wire is gray/black and diesel wait to start wire is ORANGE / black (-) see direct fax document #1090. Both wires are located on the center of the firewall. There are two black plugs, the wires are in the top plug without the white insert. The tach wire can also be found at the ECM on the passenger side firewall in connector C-1, pin 8.
Wait to start
<>Brake Wire	WHITE/ tan	+	at brake pedal switch
Parking Brake
<>Horn Trigger	BLACK/ red	-	steering column
Memory Seat 1
Memory Seat 2
Memory Seat 3

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Wiring Diagram for 98 dodge ram 1500

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.