1999 malibu 2nd ignition

need help on ignition 2 wire at ignition switch,trying to install a designtech 2100 remote start, wireing diagram says ignition 2 should be 12 volts in run and start but not in acc or off, mydark green ignition 2 wire shows 12 volts in everything but off. ihave been checking wires and trying to hook this thing up for three days, have bypass, car will turn over but will not start when wired according to diagram,

any help would be appreciated

                   thank you, wambam

D GREEN Wire Powers Powertrain Control Module (PCM) And Body Computer Module (BCM)

What ByPass are you using??

thanks for the reply, i am useing the bypass from designtech, i guess this remote start that i have will not work on the 1999 malibu because the wireing instructions tell me that the ignition 2 wire can't be hot in the acc position, even in the install vidio it makes a spiecial poit that it must be off or ground in acc,

the bypass modual i have is to bypass the passlock system but if the green wire is hot in acc it won't work right ether,

will contact designtech, by he way the model # is 20921will wait a few days and see if anybody has anything else that might help

                         thanks a lot,   wambam 

thanks will give it a nother try, the weather has turned bad here so may be a couple of days befor i can get to it, i have to work outside under a car port and i am a warm weather mechanic, thanks a lot i will let you know how it works out,

life is wonderful

               wambam