2002 Honda Accord alarm/remote start

Vehicle is a 2002 accord SE. Equipment: as2520 autostart. HM-t100 for bypass portion. HODL for door locks/alarm interface Problem: Door lock unit(hodl)-I hooked everything up, the door switch out I hooked to the green orange wwire on female connector E on the fuse box. Then I hooked up the HODL violet wire to the brown wire at pin A15 of the K connector behind fuse box. Something isen't right on this, I don't have any control. My assumption is I have the wrong data connector. Where is the "DATA" connector, also do I have the correct door switch out? Second problem with bypass kit, hmt100 says to connect to the red wire (data wire) and connect the orange wire of the bypass kit to the blue syncro wire, and then plug the black ground to the BROWN / black ground wire. Are these wires the ones at the green plug near where you plug the key in? Will these 2 kits work together on the same data wire?

The AS2560 has all the door lock options and security options built in. I don't know why you are using a HODL.

We'll I bought it because It said it controlled the trunk/door locks and factory security. It however doesn't control the trunk. I guess the main problem is the bypass kit, where are the RED / blue and ground wires I need to connect the datawires from. From my reading, is that you need to have the system disarm the factory alarm before you can trigger the trunk, or the remote start...

Honda | | Accord | | 1998 - 2002
Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	BLACK/ WHITE
Ignition #1:	BLACK / YELLOW	IGNITION SWITCH HARNESS
Ignition #2:	YELLOW	IGNITION SWITCH HARNESS
Ignition #3:
Accessory:	WHITE/ BLACK	IGNITION SWITCH HARNESS
Brake Light:	WHITE/ BLACK	AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:	BLUE	AT COIL MODULE
Parking Lights:	RED / BLACK	AT FUSE BLOCK ON DRIVER'S SIDE
Headlights:
Diesel Glow Plug:
Clutch Bypass Wire:
Notes:	* This vehicle is equipped with a transponder immobilizer system; See Installation Note #144 - Bypassing Transponder Theft Systems.
Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	WHITE	IGNITION SWITCH HARNESS
OEM Alarm Disarm:	BLUE	INSIDE OF DRIVER'S DOOR
OEM Horn:	BLUE/GREEN (-)	IN STEERING COLUMN HARNESS
Power Lock:	BLACK/ BLUE (-)	PASSENGER SIDE FUSE BOX**
Power Unlock:	ORANGE (-)	PASSENGER SIDE FUSE BOX**
Trunk Release:	WHT/RED+	# PIN GRAY CONN. ABOVE DRIVER'S KICK
Alarm Input Wire:	BLACK/ WHITE (-)	4 PIN GREEN CONN. IN PASS FUSE BOX
Notes:	** See Note#201 Negative Trigger Door Locks

The remote start unit has a wire that will send a neg pulse out before starting, this must go to the Disarm wire in the drivers door. As you can see from the above chart the door locks are a simple tie in. As for the bypass unit I can't find a installation manual and I dont remember.Craig

Ok, if I do go with out using an alarm module, where is the factory disarm wire on the 02 accord. Is there a way with out using a relay behind the glove box on this model?

Any ideas how to disarm the alarm with the press of the trunk button? The alarm goes off when we hit the trunk button.

Without reading the Auto-start manual I would be only guessing. You need to find a neg output wire that will send a signal to the disarm wire in the car before opening the trunk. If you unlock the doors first the alarm shouldn't go off. There are a lot of options on these units such as a neg pulse for the horn. For example if there is a option for the horn to blow a second before the trunk opens then you could use this horn wire for a disarm wire. Also without researching this to much you may be able to trigger to dome light to disarm the system.Craig