Ford Explorer 2003 Door and Window prob.

I having two window rollup modules for two windows with following wiring diagram:

• Pink - To Accessory
• Green - Left Motor
• White - Left Switch
• Orange - 500ma Activation
• Black - Ground
• Red - +12 Volt
• Blue - Right Motor
• Brown - Right Switch

It is also saying that I have to cut window wire?!? Where I have to connect the Green, the White, the Blue and the Brown wire to, if I wanna rollup all 4 windows (keep in mind I have 2 modules)??? Which cables I have to cut?

Can someone tell me where exatly the GEM is sitting? I tried the reference guide #1093 to check if I have a GEM or a factory alarm. Both test failed. Does it mean that I don't have GEM? Or is it just not falling in sleep? My question is concerning about the four door trigger wires (YELLOW / BLACK, LT. GREEN / YELLOW, GRAY / RED, PINK / LT. BLUE) and the trunk trigger (WHITE / PURPLE). Refer to #1076 I have to put diodes right at the GEM and and at the negative alarm trigger. Do I need that if I don't have the GEM. If I have a GEM where can I find and does it have all those door/trunk trigger wires connected to it?

Thanks in advance for your help....

Patrick

Any suggestions?

I used now the door trigger which is may not a good solution, because now I can't use the open door warning anymore? Need help for the window module.

Asianwolf RS8000 Remote Start works fine. Without injection or tach signal. It has a software which check the starter cable to stop cranking.

Sorry I mean I used the dome light...

Still need help for the window module. Can someone tell me at least the wires and the location for the power windows on a Ford Explorer 2003?

Patrick